Ford Truck Enthusiasts Forums - Search Results
 

Go Back   Ford Truck Enthusiasts Forums > Search Forums
Log In 


Showing results 1 to 15 of 433
Search took 0.44 seconds.
Search: Posts Made By: Blurry94
Forum: Lightning, Harley-Davidson F-150, Roush F-150 & Saleen F-150 07-18-2016, 09:22 PM
Replies: 3
Views: 179
Posted By Blurry94
Yes, the tube bumpers were factory options.

Yes, the tube bumpers were factory options.
Forum: Lightning, Harley-Davidson F-150, Roush F-150 & Saleen F-150 07-14-2016, 05:33 PM
Replies: 3
Views: 179
Posted By Blurry94
$4000 is about right for one with 150k miles on...

$4000 is about right for one with 150k miles on it and in good shape. One with 90K on it, I would expect to pay around $6-7k, bone stock and in nice condition. With a salvage title, you just have...
Forum: Small Block V8 (221, 260, 289, 5.0/302, 5.8/351W) 07-03-2016, 11:50 PM
Replies: 3
Views: 211
Posted By Blurry94
How exactly are you attempting to prime the oil...

How exactly are you attempting to prime the oil system?

I normally use a cordless drill to prime the oil system and the pump yields a pretty heavy strain on the drill when priming. I didn't count...
Forum: Clutch, Transmission, Differential, Axle & Transfer Case 07-03-2016, 07:34 AM
Replies: 4
Views: 174
Posted By Blurry94
How does the fluid level look?

How does the fluid level look?
Forum: Small Block V8 (221, 260, 289, 5.0/302, 5.8/351W) 07-02-2016, 11:30 PM
Replies: 5
Views: 231
Posted By Blurry94
500 ft/lb of torque at the crank or the rear...

500 ft/lb of torque at the crank or the rear wheels?
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 07-02-2016, 11:22 PM
Replies: 1
Views: 167
Posted By Blurry94
You can put a timing light on it to check for...

You can put a timing light on it to check for spark...if it doesn't flash, then it's not firing. Ignition Control Module (ICM) would my first guess and then possibly the coil. Most auto parts...
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 06-28-2016, 06:27 PM
Replies: 16
Views: 737
Posted By Blurry94
Pull the spout connector out and advance the base...

Pull the spout connector out and advance the base timing a few degrees. That one is free, easy and noticeable, by the seat-of-the-pants dyno.
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 06-16-2016, 05:09 PM
Replies: 23
Views: 898
Posted By Blurry94
That's what I've seen as well, and those folks...

That's what I've seen as well, and those folks have had very good experiences after ditching OE ecu. However, I've noticed the reason for some to switch to a stand-alone trans controller is because...
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 06-14-2016, 07:27 PM
Replies: 23
Views: 898
Posted By Blurry94
And those that have aftermarket OE tuning...

And those that have aftermarket OE tuning software can continue to use that to tune their electronic transmissions with the factory ECU and aftermarket EFI. Or otherwise use the factory ECU (without...
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 06-13-2016, 10:02 PM
Replies: 23
Views: 898
Posted By Blurry94
You CAN use aftermarket EFI and keep your stock...

You CAN use aftermarket EFI and keep your stock ECU to control the transmission.
Forum: Supercharger, Turbocharger, Nitrous Oxide & Water/Methanol Injection 05-31-2016, 06:09 PM
Replies: 2
Views: 396
Posted By Blurry94
That looks like it will be a lot of fun to drive....

That looks like it will be a lot of fun to drive.

I recommend you taking it somewhere to have it tuned, then you wont have to worry about how much boost it will make. A good wideband would be a...
Forum: Performance & General Engine Building 05-12-2016, 07:20 PM
Replies: 3
Views: 272
Posted By Blurry94
I like Bostik nickle based Never-Seeze. Mix it...

I like Bostik nickle based Never-Seeze. Mix it with a generous amount of your favorite rust penetrate, i.e. Kroil, Monolex, PB Blaster (not wd-40) etc..., and that will yield and great anti-seize...
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 05-03-2016, 07:23 PM
Replies: 11
Views: 388
Posted By Blurry94
Try this: Missing or Damaged Serial Plate or...

Try this:

Missing or Damaged Serial Plate or Title | Department of Revenue (http://dor.georgia.gov/missing-or-damaged-serial-plate-or-title)
Forum: Small Block V8 (221, 260, 289, 5.0/302, 5.8/351W) 03-12-2016, 11:35 PM
Replies: 32
Views: 1,134
Posted By Blurry94
A little more engine info would be helpful...what...

A little more engine info would be helpful...what are the specs on the 'RV cam', and the FR heads?
The first thing that grabs my attention to the fact that it will only idle is the over-sized...
Forum: Supercharger, Turbocharger, Nitrous Oxide & Water/Methanol Injection 03-12-2016, 11:04 PM
Replies: 3
Views: 431
Posted By Blurry94
Check the blower belt, make sure it's tight. If...

Check the blower belt, make sure it's tight. If that's good, then it may simply be the pulley combo you're using. Going with a smaller blower pulley and/or larger crank pulley will spin the blower...
Showing results 1 to 15 of 433

 
Forum Jump
 


All times are GMT -5. The time now is 06:02 PM.

 

Advertising - Terms of Use - Privacy Statement - Terms of Service - Jobs
This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. FordŽ is a registered trademark of the Ford Motor Company.

vbulletin Admin Backup