Ford Truck Enthusiasts Forums - Search Results
 

Go Back   Ford Truck Enthusiasts Forums > Search Forums
Log In 


Showing results 1 to 15 of 500
Search took 0.29 seconds.
Search: Posts Made By: Scratcher
Forum: Pre-Power Stroke Diesel (7.3L IDI & 6.9L) 06-09-2016, 07:56 PM
Replies: 0
Views: 101
Posted By Scratcher
T19 Manual tranny/ throwout bearing squeak

Had the clutch done on this just over a year ago. Took it back just before the warranty was up with a throw out bearing squeak (Sounds like a cricket unless I apply light pressure on the clutch...
Forum: Pre-Power Stroke Diesel (7.3L IDI & 6.9L) 07-11-2015, 04:56 PM
Replies: 8
Views: 508
Posted By Scratcher
The brake lights were working. All fixed now....

The brake lights were working. All fixed now. Wiring issue at the rear!
Forum: Pre-Power Stroke Diesel (7.3L IDI & 6.9L) 07-11-2015, 03:49 PM
Replies: 287
Views: 20,964
Posted By Scratcher
Installed LMC weather seals on drivers side. The...

Installed LMC weather seals on drivers side. The window seals were a bear to get in with the windows still in. WD40 helped though. Now my door won't close all the way un less I body press is from the...
Forum: Pre-Power Stroke Diesel (7.3L IDI & 6.9L) 07-06-2015, 02:54 PM
Replies: 7
Views: 411
Posted By Scratcher
The lever arm that attaches to the splined shaft...

The lever arm that attaches to the splined shaft on the cross bolt is shot. New one ordered and shipped to shop
Forum: Pre-Power Stroke Diesel (7.3L IDI & 6.9L) 07-04-2015, 09:06 AM
Replies: 7
Views: 411
Posted By Scratcher
clutch fail 250mls from home

Just got the clutch replaced and did the pushrod upgrade 500 MLS ago. Pedal is going to the floor and will no actuate the pushrod. There is fluid in the MC.
Forum: Pre-Power Stroke Diesel (7.3L IDI & 6.9L) 06-27-2015, 01:03 PM
Replies: 10
Views: 369
Posted By Scratcher
Thanks to all who replied and helped. Really...

Thanks to all who replied and helped. Really appreciated! :))
Forum: Pre-Power Stroke Diesel (7.3L IDI & 6.9L) 06-25-2015, 05:53 PM
Replies: 10
Views: 369
Posted By Scratcher
So I can just leave the old unit as is and...

So I can just leave the old unit as is and connect a new electronic controller? All the wiring is already disconnected from the old one anyway.
Forum: Pre-Power Stroke Diesel (7.3L IDI & 6.9L) 06-25-2015, 09:32 AM
Replies: 10
Views: 369
Posted By Scratcher
Brake Controller question

Never towed more than a single axle non braked trailer, but that's about to change! Truck came with the controller in the pic but its disconnected. Wires cut and taped. So my question is what kind of...
Forum: Pre-Power Stroke Diesel (7.3L IDI & 6.9L) 06-06-2015, 11:44 AM
Replies: 8
Views: 508
Posted By Scratcher
tail lights out!

I can't figure this out. Both turn signals work at the rear but I have no tail lights. Checked the filaments on the bulbs and I checked fuses. Just can't figure it out.:-banghead
Forum: Pre-Power Stroke Diesel (7.3L IDI & 6.9L) 05-26-2015, 03:46 PM
Replies: 18
Views: 1,642
Posted By Scratcher
I changed mine out last year for a gear...

I changed mine out last year for a gear reduction. Spins faster. Its the way to go for a diesel. Faster cranking is good!!
Forum: Michigan Chapter 05-06-2015, 12:30 PM
Replies: 10
Views: 451
Posted By Scratcher
Well since the truck is 30 years old there's lots...

Well since the truck is 30 years old there's lots of rust. Its possible they may be the original joints since it was pretty low mileage when I got it. It had only been used a couple of times a year...
Forum: Michigan Chapter 05-06-2015, 08:18 AM
Replies: 10
Views: 451
Posted By Scratcher
Not sure actually. No free play in the shaft. I...

Not sure actually. No free play in the shaft. I raised the rear and ran it in gear and heard nothing. Lowered it and rocked it back and forth........nothing.


When I drive it I get a squeaking...
Forum: Michigan Chapter 05-06-2015, 08:12 AM
Replies: 10
Views: 451
Posted By Scratcher
NW side. Thanks for the info:-X22

NW side. Thanks for the info:-X22
Forum: Michigan Chapter 05-05-2015, 05:18 PM
Replies: 10
Views: 451
Posted By Scratcher
Just moved to GR looking for a shop

Moved to Grand Rapids from Indiana recently. We love it here!:D


I have a 83 F250 6.9IDI RWD. Looking for a reliable honest shop that can do my U joints on the driveshaft. I do all my own engine...
Forum: Pre-Power Stroke Diesel (7.3L IDI & 6.9L) 04-25-2015, 07:43 PM
Replies: 11
Views: 650
Posted By Scratcher
Advances injection timing by injecting fuel into...

Advances injection timing by injecting fuel into the combustion chamber earlier than when its warm. Look at the tail pipe too and you will see more smoke than normal. All perfectly normal. No need to...
Showing results 1 to 15 of 500

 
Forum Jump
 


All times are GMT -5. The time now is 04:23 PM.

 

Advertising - Terms of Use - Privacy Statement - Terms of Service - Jobs
This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. FordŽ is a registered trademark of the Ford Motor Company.

vbulletin Admin Backup