Ford Truck Enthusiasts Forums - Search Results
 

Go Back   Ford Truck Enthusiasts Forums > Search Forums
Log In 


Showing results 1 to 15 of 151
Search took 0.19 seconds.
Search: Posts Made By: brad1979
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 06-16-2016, 07:01 PM
Replies: 59
Views: 2,962
Posted By brad1979
Also I forgot to mention, if we do proceed with...

Also I forgot to mention, if we do proceed with the bezel drawing I have the complete dash now and a template can be drawn up for drilling the holes and slot.
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 06-16-2016, 06:56 PM
Replies: 59
Views: 2,962
Posted By brad1979
Here's the update. I have researched to death an...

Here's the update. I have researched to death an alternate fog light switch, as the factory switch is unobtanium. The easiest option would be to get a long lever toggle switch similar to this: JEGS...
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 06-12-2016, 06:30 PM
Replies: 24
Views: 574
Posted By brad1979
It has been many years since I looked at a...

It has been many years since I looked at a wheelchair van, but I recall it being lifted in the rear to allow for the dropped floor and when you deployed the ramp a cylinder compressed the rear spring...
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 06-11-2016, 08:01 AM
Replies: 59
Views: 2,962
Posted By brad1979
Do you mean just the "fog lamp" bezel? I didn't...

Do you mean just the "fog lamp" bezel? I didn't take the whole dash because it was a/c. I just grabbed the switch and fog lamp bezel. I figure I can cut mine. If Gary is serious about measuring it pm...
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 06-10-2016, 09:28 PM
Replies: 24
Views: 574
Posted By brad1979
What I have seen in wheelchair vans, is a...

What I have seen in wheelchair vans, is a hydraulic cylinder that compresses the springs to lower it. Not sure what happens to release the pressure to let it back up and travel normally but it may be...
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 06-10-2016, 09:24 PM
Replies: 59
Views: 2,962
Posted By brad1979
So the black truck I almost bought in the winter...

So the black truck I almost bought in the winter for $500 ended up in a local junkyard, it was way past saving, rusty would be a compliment. I snagged the entire fog light setup wiring and all, along...
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 04-25-2016, 07:18 AM
Replies: 24
Views: 575
Posted By brad1979
I've used off the shelf color coat before and it...

I've used off the shelf color coat before and it seemed to cover better and be less runny than the custom mix, but it has been a few years. The good news is the color looks like a near perfect match...
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 04-24-2016, 08:45 PM
Replies: 24
Views: 575
Posted By brad1979
I was about to reply, but looked at the ebay pics...

I was about to reply, but looked at the ebay pics of the set you picked up first and sure enough, the bottoms are different. 87 up maybe? Too bad they aren't correct, sucks to buy the wrong parts. I...
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 04-24-2016, 02:43 PM
Replies: 24
Views: 575
Posted By brad1979
Here is what both sides look like at the top. ...

Here is what both sides look like at the top.
http://cimg5.ibsrv.net/gimg/www.ford-trucks.com-vbulletin/2000x1504/80-image_fda918ee26f0a744a573e638b9a987514b81abb3.jpeg
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 04-24-2016, 11:41 AM
Replies: 24
Views: 575
Posted By brad1979
The eBay set are correct for what I need,...

The eBay set are correct for what I need, unfortunately there was only one set. The NON headliner ones are rounded off above the door and have a finished end. I will post a photo later. Thanks again...
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 04-24-2016, 11:27 AM
Replies: 24
Views: 575
Posted By brad1979
Unless I am mistaken, the numbers on the part...

Unless I am mistaken, the numbers on the part themselves are not the part numbers. I have searched around the local yards and no luck. Found a complete parts truck with one good pillar trim in the...
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 04-22-2016, 08:32 AM
Replies: 24
Views: 575
Posted By brad1979
I re-coloring all my interior as it has faded on...

I re-coloring all my interior as it has faded on some panels. So color is no issue.
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 04-22-2016, 08:00 AM
Replies: 24
Views: 575
Posted By brad1979
I am also looking for a set of NON headliner...

I am also looking for a set of NON headliner A-pillar trim pieces. Mine are cracked. I need both sides. If anyone has a line on set it would be appreciated. Keep in mind I'm in Canada. Thanks.
Forum: 1948 - 1956 F1, F100 & Larger F-Series Trucks 03-29-2016, 07:33 PM
Replies: 17
Views: 1,238
Posted By brad1979
Funny, without seeing where you were from, I saw...

Funny, without seeing where you were from, I saw Mercury, a truck and quad in the background, and the garage stucco, and thought "that looks just like Edmonton". Looks like a great project.
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 03-05-2016, 09:26 PM
Replies: 41
Views: 1,243
Posted By brad1979
I have a Wildcat Flash brand, looks identical. I...

I have a Wildcat Flash brand, looks identical. I mounted it with the factory bolts with no problem. I don't think my push bar has square holes. It probably helps to have the threads really clean so...
Showing results 1 to 15 of 151

 
Forum Jump
 


All times are GMT -5. The time now is 02:56 AM.

 

Advertising - Terms of Use - Privacy Statement - Terms of Service - Jobs
This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. FordŽ is a registered trademark of the Ford Motor Company.

vbulletin Admin Backup