Ford Truck Enthusiasts Forums - Search Results
 

Go Back   Ford Truck Enthusiasts Forums > Search Forums
Log In 


Showing results 1 to 15 of 499
Search took 0.38 seconds.
Search: Posts Made By: tecgod13
Forum: Pre-Power Stroke Diesel (7.3L IDI & 6.9L) 06-24-2016, 11:58 PM
Replies: 33
Views: 645
Posted By tecgod13
Factory ATS draws oil from the same location at...

Factory ATS draws oil from the same location at the back of the engine. The pressure sender is relocated to the top of the turbo where it tees off some fancy fitting Ford made.

Aftermarket ATS...
Forum: Pre-Power Stroke Diesel (7.3L IDI & 6.9L) 06-23-2016, 03:42 PM
Replies: 46
Views: 819
Posted By tecgod13
The steering wheel shouldn't be connected to the...

The steering wheel shouldn't be connected to the starting circuit, but its possible the linkage that runs down the steering column is worn out, especially if its a tilt column. May need to...
Forum: Pre-Power Stroke Diesel (7.3L IDI & 6.9L) 06-23-2016, 03:37 PM
Replies: 12
Views: 354
Posted By tecgod13
As stated above, its a pain in the @$$ to convert...

As stated above, its a pain in the @$$ to convert a frame from 2wd to 4x4. This is speaking from experience, and I went with a solid axle which in theory is easier... but still requires a complete...
Forum: Pre-Power Stroke Diesel (7.3L IDI & 6.9L) 06-23-2016, 03:34 PM
Replies: 33
Views: 645
Posted By tecgod13
You don't want to tee in temp gauges. A tee...

You don't want to tee in temp gauges. A tee doesn't let the sender get the flow of the fluid. Pressure gauges are fine to tee in as the pressure is the same everywhere.

You can remove the stock...
Forum: Pre-Power Stroke Diesel (7.3L IDI & 6.9L) 06-15-2016, 07:53 PM
Replies: 7
Views: 361
Posted By tecgod13
How do the radiator fins look? Are they nice and...

How do the radiator fins look? Are they nice and clean and straight? or blocked up with mud and bugs, and squished over in places? Could also be a blocked radiator. One suggestion has been to...
Forum: Pre-Power Stroke Diesel (7.3L IDI & 6.9L) 06-15-2016, 07:47 PM
Replies: 4
Views: 183
Posted By tecgod13
Sounds like a good solid plan.

Sounds like a good solid plan.
Forum: Pre-Power Stroke Diesel (7.3L IDI & 6.9L) 06-13-2016, 09:41 PM
Replies: 7
Views: 361
Posted By tecgod13
The gauge isn't really accurate. If you really...

The gauge isn't really accurate. If you really want to know how warm it is, you need to get a 'real' gauge that tells you the actual temp.

There are a number of things that may be wrong causing...
Forum: Pre-Power Stroke Diesel (7.3L IDI & 6.9L) 06-08-2016, 09:14 PM
Replies: 12
Views: 216
Posted By tecgod13
Sounds like the voltage regulator. You can check...

Sounds like the voltage regulator. You can check voltage at the batteries, and have someone rev up the engine to see what happens. I'm not 100% positive as I've not been under the hood of an 86',...
Forum: Pre-Power Stroke Diesel (7.3L IDI & 6.9L) 06-06-2016, 09:42 PM
Replies: 35
Views: 12,829
Posted By tecgod13
This is a 5 year old thread.... who knows where...

This is a 5 year old thread.... who knows where that truck is now
Forum: Pre-Power Stroke Diesel (7.3L IDI & 6.9L) 05-23-2016, 09:28 PM
Replies: 2
Views: 148
Posted By tecgod13
If you have a spare injector, or line, swap one...

If you have a spare injector, or line, swap one or the other.
If it still leaks, its the other side of the connection...

If you don't have a spare of either, you could try swapping the injector...
Forum: Clutch, Transmission, Differential, Axle & Transfer Case 05-22-2016, 05:59 PM
Replies: 4
Views: 238
Posted By tecgod13
The ZF5 is different looking than the other...

The ZF5 is different looking than the other manual trans. I ant to say it has diagonal ribs on the side of the case. Google some pictures to see what they look like.

As far as the motor, not...
Forum: Pre-Power Stroke Diesel (7.3L IDI & 6.9L) 05-19-2016, 06:46 PM
Replies: 151
Views: 17,670
Posted By tecgod13
Rear driveshaft, 4x4, ext cab, ZF5

Looking for a rear driveshaft for my '93 F250 extended cab, long bed, 4x4, ZF5 transmission. I think one from a C6 truck would also work, but E4OD will most likely be too short. This would have the...
Forum: Pre-Power Stroke Diesel (7.3L IDI & 6.9L) 05-19-2016, 09:08 AM
Replies: 19
Views: 480
Posted By tecgod13
No that will NOT work, what an idiot... Like...

No that will NOT work, what an idiot...
Like mentioned all the lines need to be the same length.

Have you tried looking at junkyards or on Ebay?
Forum: Pre-Power Stroke Diesel (7.3L IDI & 6.9L) 05-16-2016, 09:00 AM
Replies: 26
Views: 1,036
Posted By tecgod13
Don't use TTB springs on a solid axle. It will...

Don't use TTB springs on a solid axle. It will ride like chit.
I suppose if all you are doing is plowing with it, the extra weight on the front might mellow the springs some. But I would NOT...
Forum: Pre-Power Stroke Diesel (7.3L IDI & 6.9L) 05-15-2016, 05:56 PM
Replies: 19
Views: 480
Posted By tecgod13
The sensor is there for the ford timing tool. ...

The sensor is there for the ford timing tool. Its not needed for the operation of the engine, BUT it is essential as a spacer because the #1 line is shorter to compensate for the sensor.
As you...
Showing results 1 to 15 of 499

 
Forum Jump
 


All times are GMT -5. The time now is 05:39 PM.

 

Advertising - Terms of Use - Privacy Statement - Terms of Service - Jobs
This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. FordŽ is a registered trademark of the Ford Motor Company.

vbulletin Admin Backup