Ford Truck Enthusiasts Forums - Search Results

Go Back   Ford Truck Enthusiasts Forums > Search Forums
Log In 

Showing results 1 to 15 of 379
Search took 0.28 seconds.
Search: Posts Made By: hcbph
Forum: 2004 - 2008 F150 02-06-2016, 07:15 AM
Replies: 16
Views: 998
Posted By hcbph
I assume you know about the 5.4 plug issue. If...

I assume you know about the 5.4 plug issue. If not, they used a 2 piece plug that can carbon up around the tip and cause them to separate while trying to remove them for a plug change. That can end...
Forum: 2004 - 2008 F150 10-17-2015, 07:22 AM
Replies: 2
Views: 344
Posted By hcbph
Doesn't your 2005 have 6 bolt wheels? 2000...

Doesn't your 2005 have 6 bolt wheels? 2000 should have 5 lug wheels if it's like the 97 I had. May physically fit but you'd either have to get different axels and have them drilled or mix rims.
Forum: 2004 - 2008 F150 04-26-2015, 09:27 AM
Replies: 7
Views: 678
Posted By hcbph
Zeckhausen Racing...

Zeckhausen Racing (

Check out the above. I put them on my 07 4x2 heavy half a couple of years ago,...
Forum: 2004 - 2008 F150 08-11-2014, 11:49 AM
Replies: 19
Views: 4,470
Posted By hcbph
Most Bang for the buck

Depending on what the O.P. plans for the truck, there are some decent options for good trucks out there. Unless you 'need' a 4x4, watch for 4x2's as they can be gotten for a good price at times...
Forum: 2004 - 2008 F150 01-10-2014, 09:32 AM
Replies: 6
Views: 1,928
Posted By hcbph

If you're still running the original hub, it's a 1 piece. As mentioned, Centric has a kit that splits the hub and rotor apart into a 2 piece unit. I've had a set on my truck for almost a year now. ...
Forum: Modular V8 (4.6L, 5.4L) 11-20-2013, 07:37 AM
Replies: 48
Views: 25,996
Posted By hcbph

Great info here, have not seen some of these things apart before.
I'm sure it will run like a champ when you're done.
Well done.
Forum: 2004 - 2008 F150 11-15-2013, 07:08 AM
Replies: 14
Views: 1,198
Posted By hcbph

I had this type of situation once after a relative ran a vehicle though water very fast, splashing the engine. I had a can of LPS water dispersant spray and I took every connector apart in the...
Forum: 2004 - 2008 F150 11-04-2013, 09:13 AM
Replies: 2
Views: 712
Posted By hcbph

I just sold a 97 Scab with a 4.6L, stock truck. I also have a 07 5.4 Scab with the heavy half option(4.10 rear, 8' box) also stock, and both are 2wd.
They both ended up around the same mpg around...
Forum: 2004 - 2008 F150 10-27-2013, 08:53 AM
Replies: 4
Views: 1,519
Posted By hcbph

If you're possibly replacing it anyway, consider the Centric's 2 piece replacement front wheel assembly. It makes it like T-Bird is where the rotor is separate from the hub so the rotor can be...
Forum: Brakes, Steering, Suspension, Tires, & Wheels 07-26-2013, 03:29 PM
Replies: 1
Views: 326
Posted By hcbph

If the piston is not retracting, rebuild or replace the caliper. You don't want to risk your safety on a bad caliper.
Forum: Brakes, Steering, Suspension, Tires, & Wheels 07-26-2013, 03:25 PM
Replies: 3
Views: 433
Posted By hcbph
Replacement hubs

Direct replacements. Remove the caliper & mount, remove the spindle nut and slide off the original hub assembly. Slip the new hub onto the spindle and torque the new spindle nut down to specs. I...
Forum: 2004 - 2008 F150 07-26-2013, 03:13 PM
Replies: 4
Views: 1,479
Posted By hcbph

Go here and plug in your trucks info:
Champion Automotive Spark Plugs and Glow Plugs - In Stock for Your Tune-Up! (
Forum: Brakes, Steering, Suspension, Tires, & Wheels 07-24-2013, 11:33 AM
Replies: 3
Views: 433
Posted By hcbph

I can't speak to the bleeder question, but I can speak to the hub on a 4x2. It's a one piece unit: the rotor and hub is a 1 piece unit with bearings pressed into them.

If you want a two piece...
Forum: Brakes, Steering, Suspension, Tires, & Wheels 07-24-2013, 11:19 AM
Replies: 5
Views: 420
Posted By hcbph

I think you should figure out the weight of your truck along with the max load you plan to carry first. My truck came with E's but the winter tires are D's. I just know the load difference and...
Forum: 2004 - 2008 F150 07-24-2013, 10:56 AM
Replies: 18
Views: 2,122
Posted By hcbph

I'm not the norm here but take it for what it's worth.
I have a 07 8200 lb gvw F150, extended cab with a 8' box. It's got the 5.4L engine and 4.10 gears and it's a 4x2.
90% of my driving is around...
Showing results 1 to 15 of 379

Forum Jump

All times are GMT -5. The time now is 07:37 AM.


Advertising - Terms of Use - Privacy Statement - Terms of Service - Jobs
This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. FordŽ is a registered trademark of the Ford Motor Company.

vbulletin Admin Backup