Ford Truck Enthusiasts Forums - Search Results
 

Go Back   Ford Truck Enthusiasts Forums > Search Forums
Log In 


Showing results 1 to 15 of 50
Search took 0.19 seconds.
Search: Posts Made By: FrankGRUN
Forum: Big Block V8 - 385 Series (6.1/370, 7.0/429, 7.5/460) Yesterday, 11:06 AM
Replies: 7
Views: 362
Posted By FrankGRUN
I had to replace the 460 in my RV 2 years ago....

I had to replace the 460 in my RV 2 years ago. After a considerable search, I went with Promar Engines. They offered a completely remanufactured long block including new camshaft, lifters, pushrods,...
Forum: 1968-2013 Full Size Vans 07-12-2016, 10:47 PM
Replies: 398
Views: 176,526
Posted By FrankGRUN
Oz Econoline. BIG MISTAKE! I'm aging more rapidly...

Oz Econoline. BIG MISTAKE! I'm aging more rapidly than I thought! I didn't use the Rancho Stabilizer!!! When I went over to and under the van to take pictures of the installation, I discovered that I...
Forum: 1968-2013 Full Size Vans 07-12-2016, 12:28 PM
Replies: 398
Views: 176,526
Posted By FrankGRUN
I can't comment about chassis changes from 1976...

I can't comment about chassis changes from 1976 to 1982 for the E350, but I noticed the same thing about Summit's description of the RS5402 Stabilizer. Nonetheless, I purchased the part from Summit...
Forum: 1968-2013 Full Size Vans 07-11-2016, 11:06 AM
Replies: 398
Views: 176,526
Posted By FrankGRUN
Darin, I used the Rancho RS5000 Steering...

Darin, I used the Rancho RS5000 Steering Stabilizer Part Number RS5402 and purchased it from Summit Racing. It is Summit part number RAN RS5402. Cost $55! Brackets and Damper included.
Forum: 1968-2013 Full Size Vans 07-11-2016, 01:00 AM
Replies: 398
Views: 176,526
Posted By FrankGRUN
Just a real fight for the tight space to locate...

Just a real fight for the tight space to locate the outer half of the frame mounted bracket. Very tough to get at! After that the install was very easy. Best if you have very small hands!
Forum: Fuel Injection, Carburetion & Fuel System 07-10-2016, 02:25 AM
Replies: 4
Views: 428
Posted By FrankGRUN
Your suggestion that the throttle was being...

Your suggestion that the throttle was being stopped from full travel by a mis-adjusted kick down rod was correct! I finally got back to the problem in past few days and replaced the Edelbrock 1411...
Forum: 1968-2013 Full Size Vans 07-10-2016, 02:20 AM
Replies: 5
Views: 314
Posted By FrankGRUN
A few comments by way of an update. There was...

A few comments by way of an update. There was good response in the sub-forum suggesting that the throttle was being stopped from full travel by a mis-adjusted kick down rod. I finally got back to the...
Forum: 1968-2013 Full Size Vans 07-10-2016, 02:04 AM
Replies: 398
Views: 176,526
Posted By FrankGRUN
Just a quick note to report that I purchased and...

Just a quick note to report that I purchased and installed a Rancho RS5402 Steering Stabilizer kit on my 1982 E350-based Motorhome with 460/C6 RWD powertrain. I was assured by the vendor (Summit...
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 07-09-2016, 11:45 PM
Replies: 6
Views: 195
Posted By FrankGRUN
A most interesting site appropriately named! Lots...

A most interesting site appropriately named! Lots of very useful info in one place! Thanks!
Forum: 1968-2013 Full Size Vans 07-09-2016, 11:38 PM
Replies: 13
Views: 475
Posted By FrankGRUN
Subford, I misunderstood! I had seen several...

Subford, I misunderstood! I had seen several vacuum routing diagrams (not necessarily Ford-based) that included the PCV valve and the vacuum modulator, cruise control and the AC controls. I have the...
Forum: 1968-2013 Full Size Vans 07-09-2016, 11:21 PM
Replies: 13
Views: 475
Posted By FrankGRUN
Jimandnena, "mouth-breather big block V8s" ---...

Jimandnena, "mouth-breather big block V8s" --- now that is both highly appropriate and beautifully descriptive! And, you are right, I totally missed the second reservoir on the drivers side stuffed...
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 07-09-2016, 02:50 AM
Replies: 6
Views: 195
Posted By FrankGRUN
Gary, the calibration parts list was very helpful...

Gary, the calibration parts list was very helpful in understanding some of the components in the emission system. The vacuum routing diagram on your site is a bit more complicated than the one I seem...
Forum: 1968-2013 Full Size Vans 07-09-2016, 02:24 AM
Replies: 13
Views: 475
Posted By FrankGRUN
Thanks for the thread suggestions. They have...

Thanks for the thread suggestions. They have really helped.

Subford, your diagram is almost exactly what I have except for two lines. One large diameter one takes off from the rear of the intake...
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 07-07-2016, 03:01 AM
Replies: 6
Views: 195
Posted By FrankGRUN
Searching for Vacuum Routing Diagram

I have a 1982 E350-based motorhome with the 460/7.5L engine with a build date of 8/82 so I assume its either at the end of 82 production or the start of the 83 run. I'm looking for the vacuum line...
Forum: 1968-2013 Full Size Vans 07-07-2016, 01:20 AM
Replies: 13
Views: 475
Posted By FrankGRUN
Thanks much for the help Jim!

Thanks much for the help Jim!
Showing results 1 to 15 of 50

 
Forum Jump
 


All times are GMT -5. The time now is 08:47 AM.

 

Advertising - Terms of Use - Privacy Statement - Terms of Service - Jobs
This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. FordŽ is a registered trademark of the Ford Motor Company.

vbulletin Admin Backup