Ford Truck Enthusiasts Forums - Search Results
 

Go Back   Ford Truck Enthusiasts Forums > Search Forums
Log In 


Showing results 1 to 15 of 500
Search took 0.31 seconds.
Search: Posts Made By: Ken Blythen
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks Yesterday, 04:34 AM
Replies: 11
Views: 204
Posted By Ken Blythen
This link might help..........BEC TV Linkage...

This link might help..........BEC TV Linkage Adjustment Info (http://www.becontrols.com/tvlinkage.shtml)
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 07-24-2016, 01:52 PM
Replies: 24
Views: 385
Posted By Ken Blythen
They left the original DS-III module in place on...

They left the original DS-III module in place on the inner fender, still wired but not operating.......then installed the new DS-II module up under the dash.
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 07-24-2016, 04:38 AM
Replies: 24
Views: 385
Posted By Ken Blythen
My F250 is an ex-California '83........originally...

My F250 is an ex-California '83........originally an EEC-III 302/AOD with a 7300lb GVWR.

When I bought it, a DS-II conversion had been done, but disguised as DS-III...........so it had mechanical...
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 07-15-2016, 02:49 AM
Replies: 22
Views: 666
Posted By Ken Blythen
https://www.novak-adapt.com/knowledge/transmission...

https://www.novak-adapt.com/knowledge/transmissions/manual/t18-t19/
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 07-11-2016, 11:22 PM
Replies: 10
Views: 249
Posted By Ken Blythen
Do you know your rear axle gearing? If it...

Do you know your rear axle gearing?

If it happens to be a crazy-high ratio like 2.47:1, then low speed city/backroad driving will tend to burn a lot of extra gas because the engine is operating...
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 07-09-2016, 06:20 PM
Replies: 12
Views: 265
Posted By Ken Blythen
I have done it in place.....but as Gary says, you...

I have done it in place.....but as Gary says, you need something to save your fingers, then get in above the shifter to put as much downward force onto the ring as you can.

Otherwise maybe a piece...
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 07-08-2016, 02:55 PM
Replies: 12
Views: 265
Posted By Ken Blythen
If it's an NP435, that ring is available in a...

If it's an NP435, that ring is available in a $17.20 kit (near the bottom of the page) here...........

https://www.novak-adapt.com/catalog/transmission/transmission-parts/np435-parts/

You have...
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 07-08-2016, 06:20 AM
Replies: 33
Views: 771
Posted By Ken Blythen
It's been pretty thoroughly covered, but your...

It's been pretty thoroughly covered, but your symptoms are typical of retarded timing.....good starting & running, but lifeless performance; that's the first thing I would check.
Synthetic oils...
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 07-04-2016, 06:23 AM
Replies: 33
Views: 749
Posted By Ken Blythen
Also, while you might have a head or gasket...

Also, while you might have a head or gasket problem, LPG generates a lot of condensation which can show as moisture in the crankcase - giving milky oil.
This is mainly if you are doing a lot of...
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 07-04-2016, 01:35 AM
Replies: 33
Views: 749
Posted By Ken Blythen
I've owned an earlier 6-cyl Falcon, but not a...

I've owned an earlier 6-cyl Falcon, but not a crossflow; I think that is just an alloy head (or alloy head II), crossflow 4.1, that was common in the Aus Ford trucks & cars, in that era.

Your...
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 06-29-2016, 01:26 AM
Replies: 51
Views: 1,157
Posted By Ken Blythen
Exactly my experience

Exactly my experience
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 06-25-2016, 03:47 AM
Replies: 42
Views: 3,300
Posted By Ken Blythen
Pavel, I'm just in the middle of finally...

Pavel, I'm just in the middle of finally installing a rebuild kit from Novak into my T19 (have intended to for 3 years).

I had said above that the magnet on the floor of these transmissions was...
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 06-25-2016, 02:44 AM
Replies: 51
Views: 1,157
Posted By Ken Blythen
I briefly considered the idea of repairing the...

I briefly considered the idea of repairing the original connector, but Rockauto had new ones for around $4 so I ordered one. While I waited for it, I just crimped terminals onto the wires & slipped...
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 06-24-2016, 10:02 PM
Replies: 51
Views: 1,157
Posted By Ken Blythen
I've also had an intermittent electrical problem...

I've also had an intermittent electrical problem that was definitley the horseshoe connector.

It was difficult to pin-point, & left me on the roadside several times while troubleshooting. I...
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 06-08-2016, 04:49 AM
Replies: 24
Views: 563
Posted By Ken Blythen
We understand that :). It's one of those 'typed...

We understand that :). It's one of those 'typed vs spoken' moments.
Showing results 1 to 15 of 500

 
Forum Jump
 


All times are GMT -5. The time now is 01:17 AM.

 

Advertising - Terms of Use - Privacy Statement - Terms of Service - Jobs
This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. FordŽ is a registered trademark of the Ford Motor Company.

vbulletin Admin Backup