Ford Truck Enthusiasts Forums - Search Results
 

Go Back   Ford Truck Enthusiasts Forums > Search Forums
Log In 


Showing results 1 to 15 of 337
Search took 0.34 seconds.
Search: Posts Made By: LxMan1
Forum: Modular V8 (4.6L, 5.4L) 07-20-2016, 03:35 AM
Replies: 2
Views: 150
Posted By LxMan1
Sounds like a possible vacuum leak making noise...

Sounds like a possible vacuum leak making noise and possibly the the miss too. Remove the belt and start it up. If the noise is gone, then it's a belt driven accessory such as the alternator...
Forum: Modular V8 (4.6L, 5.4L) 07-20-2016, 03:28 AM
Replies: 1
Views: 118
Posted By LxMan1
I would check all of the chassis grounds to the...

I would check all of the chassis grounds to the engine. I sounds like a bad ground in the engine harness perhaps?
Forum: 1968-2013 Full Size Vans 04-25-2016, 08:46 AM
Replies: 10
Views: 362
Posted By LxMan1
Moved to the correct forum. Yes, the 6 pin plug...

Moved to the correct forum. Yes, the 6 pin plug is for the trailer to package when using an electric brake controller. Most auto parts stores sell the harness to plug into it and then wire into the...
Forum: Ford Truck Parts for Sale 04-11-2016, 07:48 AM
Replies: 5
Views: 283
Posted By LxMan1
Moved to the correct forum.

Moved to the correct forum.
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 04-07-2016, 04:55 PM
Replies: 5
Views: 399
Posted By LxMan1
Moved to the correct forum. Check to make...

Moved to the correct forum.

Check to make sure the ECM grounds and body to engine grounds are properly connected.
You will need a noid light to see the injector pulses.
Forum: Modular V8 (4.6L, 5.4L) 03-26-2016, 06:57 AM
Replies: 3
Views: 252
Posted By LxMan1
Exhaust manifold leaks at the head can sound like...

Exhaust manifold leaks at the head can sound like an internal tick sometimes. Usually under load, but not always. Look for broken studs that hold the manifolds to the heads and also look for black...
Forum: Modular V8 (4.6L, 5.4L) 03-26-2016, 06:54 AM
Replies: 2
Views: 293
Posted By LxMan1
Unless you have a cracked or loose flywheel, it...

Unless you have a cracked or loose flywheel, it sounds like a rod bearing have have failed.
Forum: Expedition & Navigator 01-09-2016, 11:36 PM
Replies: 7
Views: 926
Posted By LxMan1
Moved to correct forum since this is not an...

Moved to correct forum since this is not an (5.4L) specific issue. You should get even more help from this area.
Forum: Modular V8 (4.6L, 5.4L) 01-09-2016, 11:34 PM
Replies: 13
Views: 2,030
Posted By LxMan1
Ford did this because they got tired of...

Ford did this because they got tired of customers, that are automotive illiterate, from wasting the service departments time when they bring their vehicles in because the oil pressure drops when at a...
Forum: Modular V8 (4.6L, 5.4L) 01-09-2016, 11:25 PM
Replies: 2
Views: 341
Posted By LxMan1
Welcome to the forum! It sounds like you...

Welcome to the forum!

It sounds like you either have a large air pocket in the cooling system or you have a head gasket issue. I would start by having the cooling system pressure tested to see if...
Forum: Ford Truck Parts for Sale 01-09-2016, 11:01 PM
Replies: 13
Views: 899
Posted By LxMan1
Moved to correct forum. No selling in the tech...

Moved to correct forum. No selling in the tech forums, all other for sale threads in the tech areas will be deleted.
Forum: Modular V8 (4.6L, 5.4L) 01-03-2016, 08:46 PM
Replies: 1
Views: 259
Posted By LxMan1
Clean the throttlebody.

Clean the throttlebody.
Forum: Modular V8 (4.6L, 5.4L) 01-03-2016, 08:45 PM
Replies: 59
Views: 6,803
Posted By LxMan1
Could be bad gas, could be a bad ECM, or the...

Could be bad gas, could be a bad ECM, or the mentioned vacuum leak. I use an unlit propane torch to check for vacuum leaks. the idle will raise/smooth out if it sucks propane into the leak. I would...
Forum: Fuel Injection, Carburetion & Fuel System 12-31-2015, 06:42 PM
Replies: 2
Views: 271
Posted By LxMan1
You might try RockAuto Parts Catalog...

You might try RockAuto Parts Catalog (http://www.rockauto.com) They have lots of oem parts.
Forum: Fuel Injection, Carburetion & Fuel System 12-31-2015, 06:40 PM
Replies: 1
Views: 275
Posted By LxMan1
As long as the injectors are the correct size for...

As long as the injectors are the correct size for the truck, any brand should work. Are you getting any codes? Almost sounds like a possible MAF issue, but I'm not 100% sure.
Showing results 1 to 15 of 337

 
Forum Jump
 


All times are GMT -5. The time now is 03:37 AM.

 

Advertising - Terms of Use - Privacy Statement - Terms of Service - Jobs
This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. FordŽ is a registered trademark of the Ford Motor Company.

vbulletin Admin Backup