Ford Truck Enthusiasts Forums - Search Results
 

Go Back   Ford Truck Enthusiasts Forums > Search Forums
Log In 


Showing results 1 to 15 of 500
Search took 0.31 seconds.
Search: Posts Made By: Lead Head
Forum: 1987 - 1996 F150 & Larger F-Series Trucks Today, 01:17 AM
Replies: 4
Views: 153
Posted By Lead Head
Bouncing speedometer almost always means you will...

Bouncing speedometer almost always means you will have some transmission issues.

I'd start by pulling the codes, but you'll probably be either replacing the VSS in the rear end, or the...
Forum: 1987 - 1996 F150 & Larger F-Series Trucks Today, 01:16 AM
Replies: 5
Views: 169
Posted By Lead Head
The MAP sensor could cause hard starting if it...

The MAP sensor could cause hard starting if it were bad, but it would generally also cause very poor running in general.

The ECT (coolant temp) sensor is probably the most important sensor for...
Forum: 1987 - 1996 F150 & Larger F-Series Trucks Today, 01:13 AM
Replies: 15
Views: 484
Posted By Lead Head
Well I mean a lot of people use the SuperDuty...

Well I mean a lot of people use the SuperDuty intake spider when they intercool an OBS, so presumably the SD and OBS turbo flanges are the same/similar size.
Forum: 1987 - 1996 F150 & Larger F-Series Trucks Today, 01:10 AM
Replies: 7
Views: 196
Posted By Lead Head
It could be just as simple as a stuck shift valve...

It could be just as simple as a stuck shift valve in the valvebody. I don't know enough about C6s to make a diagnosis though. Luckily C6s are cheap and easy to rebuild.
Forum: 1987 - 1996 F150 & Larger F-Series Trucks Yesterday, 11:09 AM
Replies: 4
Views: 153
Posted By Lead Head
AutoZone will usually pull codes for free

AutoZone will usually pull codes for free
Forum: 1987 - 1996 F150 & Larger F-Series Trucks Yesterday, 11:08 AM
Replies: 14
Views: 298
Posted By Lead Head
As a final check, with the key on, Pins 1, 37 and...

As a final check, with the key on, Pins 1, 37 and 57 on the PCM connector should have +12v on them.
Forum: 1987 - 1996 F150 & Larger F-Series Trucks Yesterday, 11:04 AM
Replies: 15
Views: 317
Posted By Lead Head
You need to get the code reading working first....

You need to get the code reading working first. As mentioned, at the minimum you should get Code 11.
Forum: 1987 - 1996 F150 & Larger F-Series Trucks Yesterday, 11:01 AM
Replies: 7
Views: 220
Posted By Lead Head
So you'll never buy another Autolite because you...

So you'll never buy another Autolite because you had one $4 sparkplug crack? So what? Anything mass produced can fail. I've seen sparkplugs from every single brand fail in various ways.

Also, you...
Forum: 1987 - 1996 F150 & Larger F-Series Trucks Yesterday, 10:52 AM
Replies: 52
Views: 792
Posted By Lead Head
35 still isn't enough, it should hit 40. You...

35 still isn't enough, it should hit 40. You should be able to bleed all the pressure down, and it should hit 40 PSI in one key turn. I also don't care what codes you got ages ago, or what you you...
Forum: 1987 - 1996 F150 & Larger F-Series Trucks Yesterday, 10:48 AM
Replies: 4
Views: 177
Posted By Lead Head
You don't need any equipment. You only need a...

You don't need any equipment. You only need a paperclip, a piece of paper, pencil and your eyes.

Ford ? OBD Trouble Codes (http://www.troublecodes.net/ford/)
Forum: 1987 - 1996 F150 & Larger F-Series Trucks Yesterday, 10:34 AM
Replies: 10
Views: 296
Posted By Lead Head
That is is the fresh air/recirculate vacuum...

That is is the fresh air/recirculate vacuum actuator. It wouldn't cause a no-air issue. It just opens a flap that causes the blower motor to suck air in from the cab instead of the outside.
Forum: 1987 - 1996 F150 & Larger F-Series Trucks Yesterday, 10:31 AM
Replies: 29
Views: 522
Posted By Lead Head
An '87 460 is not an EFI engine.

An '87 460 is not an EFI engine.
Forum: 1987 - 1996 F150 & Larger F-Series Trucks Yesterday, 10:26 AM
Replies: 5
Views: 169
Posted By Lead Head
Any kind of vacuum leak, etc.. will cause hard...

Any kind of vacuum leak, etc.. will cause hard starting. I recommend just replacing the entire EGR valve. If it got stuck once, it will likely do it again.
Forum: 1987 - 1996 F150 & Larger F-Series Trucks Yesterday, 10:24 AM
Replies: 4
Views: 194
Posted By Lead Head
I believe someone mentioned the FE flywheels will...

I believe someone mentioned the FE flywheels will bolt to a 460. In which case, you probably have an FE flywheel on the engine.
Forum: 1987 - 1996 F150 & Larger F-Series Trucks Yesterday, 10:19 AM
Replies: 10
Views: 351
Posted By Lead Head
All engines have blow by, and with 223,000 miles,...

All engines have blow by, and with 223,000 miles, the engine is going to have some.

Like I said, you need to take a video of what the truck is doing. Since you said holding the clutch seems to...
Showing results 1 to 15 of 500

 
Forum Jump
 


All times are GMT -5. The time now is 11:36 AM.

 

Advertising - Terms of Use - Privacy Statement - Terms of Service - Jobs
This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. FordŽ is a registered trademark of the Ford Motor Company.

vbulletin Admin Backup