Ford Truck Enthusiasts Forums - Search Results
 

Go Back   Ford Truck Enthusiasts Forums > Search Forums
Log In 


Showing results 1 to 15 of 303
Search took 0.36 seconds.
Search: Posts Made By: tempforce
Forum: 1948 - 1956 F1, F100 & Larger F-Series Trucks 05-16-2016, 09:21 AM
Replies: 8
Views: 509
Posted By tempforce
had a volare

yes, i owned a volare, i didn't like the way the suspension acted when the front end needed to be pushed.
the front end reacted different side to side. due to the placement of the axle centerlines....
Forum: Ranger & B-Series 04-13-2016, 02:25 PM
Replies: 4
Views: 296
Posted By tempforce
it's a mazda built perkins.. used in the 83-84...

it's a mazda built perkins.. used in the 83-84 trucks.
the 85-87 used a mitsubishi 2.3 turbo diesel
if you decide not to use it. people are looking for parts.
my trucks fuel filter/primer unit...
Forum: Ranger & B-Series 02-08-2016, 05:36 PM
Replies: 23
Views: 1,361
Posted By tempforce
there a small number of them left... the '83-84's...

there a small number of them left... the '83-84's had the 2.2 mazda built perkins. with 56 hp.
the '85-86' rangers used the same engine as dodge d-50 used. the mitsubishi 2.3 turbo diesel.at over...
Forum: Escape & Escape Hybrid 01-18-2016, 08:09 PM
Replies: 4
Views: 597
Posted By tempforce
if the smaller engine is driven where it in boost...

if the smaller engine is driven where it in boost most of the time, it will get worse mileage than the larger engine. if the larger engine is able to stay out of boost or in low boost conditions.
Forum: 1948 - 1956 F1, F100 & Larger F-Series Trucks 01-18-2016, 08:01 PM
Replies: 9
Views: 599
Posted By tempforce
http://cimg4.ibsrv.net/gimg/www.ford-trucks.com-vb...

http://cimg4.ibsrv.net/gimg/www.ford-trucks.com-vbulletin/400x300/80-markaro_right_rear34_22d621ebb1e279642ca08a68651fdd9f1651173d.jpg
Lincoln Mark VIII conversion
Forum: 1948 - 1956 F1, F100 & Larger F-Series Trucks 01-18-2016, 06:00 PM
Replies: 13
Views: 846
Posted By tempforce
if i would of had a 'y' block available, i would...

if i would of had a 'y' block available, i would of gone with it.. just because i've have three vehicles with the 'Y' block engine family. they sound great, run great and with the proper gearing get...
Forum: 1948 - 1956 F1, F100 & Larger F-Series Trucks 12-22-2015, 02:41 AM
Replies: 10
Views: 369
Posted By tempforce
also check your alternator for a weak diode, you...

also check your alternator for a weak diode, you can put a capacitor on the battery lead to smooth out any pulses in the current as well.
Forum: 1948 - 1956 F1, F100 & Larger F-Series Trucks 12-07-2015, 06:35 AM
Replies: 33
Views: 2,435
Posted By tempforce
long tube glass packs

on my last loud car i had a pair of mitchell's 36" 2" glass packs, with a cross over near the trans tail shaft.
nice sound except when rapping them out and letting them pop on decel going down...
Forum: Ranger & B-Series 12-06-2015, 08:31 PM
Replies: 23
Views: 1,361
Posted By tempforce
other diesel engines

check out the south american 2.5L power stroke made in brazil. by ford.
used in the rangers and range rovers.
also the newer cummins 3.4L 4bt engines.
adaptors are available to mount to any...
Forum: 1948 - 1956 F1, F100 & Larger F-Series Trucks 09-27-2015, 03:02 PM
Replies: 2
Views: 475
Posted By tempforce
where are you located? i need a steering wheel..

where are you located? i need a steering wheel..
Forum: Ranger & B-Series 09-27-2015, 07:07 AM
Replies: 9
Views: 4,625
Posted By tempforce
http://cimg1.ibsrv.net/gimg/www.ford-trucks.com-vb...

http://cimg1.ibsrv.net/gimg/www.ford-trucks.com-vbulletin/1280x1024/80-ds2_0373_eae20191e16844478a225539d2cc889082801493.jpg
depends on the load, road conditions and your speed.
on flat highway...
Forum: Other; Brakes, Electrical, Hitches, Weight Distribution & CDL Discussion 09-27-2015, 06:33 AM
Replies: 25
Views: 2,399
Posted By tempforce
the brake smart and max brake went south due to...

the brake smart and max brake went south due to factory smart brake controllers. i was lucky to find an old Kelsey Hayes unit. i'm saving it for my f100.
we are left with the inertia controllers.
Forum: 1948 - 1956 F1, F100 & Larger F-Series Trucks 05-04-2015, 07:01 PM
Replies: 131
Views: 34,406
Posted By tempforce
i'm working with a 96 mark viii, and there is a...

i'm working with a 96 mark viii, and there is a whole bunch of stuff i don't want to deal with, that the computer monitors... i'm considering the ford motorsports ecu, and then get a transmission...
Forum: 1948 - 1956 F1, F100 & Larger F-Series Trucks 05-04-2015, 06:48 AM
Replies: 131
Views: 34,406
Posted By tempforce
is the oem dash guages required for the oem ecm...

is the oem dash guages required for the oem ecm to work????
Forum: 1948 - 1956 F1, F100 & Larger F-Series Trucks 04-11-2015, 09:36 AM
Replies: 12
Views: 507
Posted By tempforce
great find and better price...

great find and better price...
Showing results 1 to 15 of 303

 
Forum Jump
 


All times are GMT -5. The time now is 06:53 AM.

 

Advertising - Terms of Use - Privacy Statement - Terms of Service - Jobs
This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. FordŽ is a registered trademark of the Ford Motor Company.

vbulletin Admin Backup