Ford Truck Enthusiasts Forums - Search Results
 

Go Back   Ford Truck Enthusiasts Forums > Search Forums
Log In 


Showing results 1 to 15 of 499
Search took 0.41 seconds.
Search: Posts Made By: donnor
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 11-26-2015, 10:50 PM
Replies: 14
Views: 713
Posted By donnor
Pumpkin swap: Easy as, well, pie.

A Dana 50 TTB differential is a direct bolt-in to a Dana 44 TTB axle. At least that was my experience when I did it to my truck about four years and 100,000+ miles ago.

dn.
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 11-15-2015, 04:34 PM
Replies: 6
Views: 393
Posted By donnor
Electrical Upgrade

Next time you are faced with a failed 1G or 2G alternator consider upgrading to the 3G. In fact, anticipate failure and begin searching for the needed wiring harness(es) and maybe even a suitable...
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 11-15-2015, 04:19 PM
Replies: 1
Views: 167
Posted By donnor
W-I-R-E-D!

Paul, you are pretty well on your own with this one. Unless you are looking for a generic harness to use in a new custom or highly modified build you will need to just chase down the copper gremlins...
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 09-05-2015, 06:42 PM
Replies: 4
Views: 263
Posted By donnor
Gearing up...

I have found they fit tightly but can usually be wedged into place without the heating. However, if that helps I do not see a down side to it. Just be sure to clean all of the debris out of the...
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 09-05-2015, 06:30 AM
Replies: 7
Views: 744
Posted By donnor
Pump or pulley?

Another possible source is later model 351s with MAF. Many late 1995 models and most all light duty 1996s are in this category. They have a pulley in place of the pump.
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 09-05-2015, 12:18 AM
Replies: 8
Views: 329
Posted By donnor
Gauging the problem...

If you have two gauges failing at the same time chances are the voltage regulator on the instrument cluster is the culprit. It is also possible a loose connection or crack on the printed circuit may...
Forum: 1978 - 1996 Big Bronco 09-04-2015, 09:44 PM
Replies: 22
Views: 1,632
Posted By donnor
True choices and options...

That is a very nice Bronco. One thing perhaps a lot of folks do not think much about is that vehicles of this vintage truly had choices / options that just do not exist today. Foremost among them...
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 05-27-2015, 06:29 PM
Replies: 9
Views: 363
Posted By donnor
Automotive roadkill?

If you want simulators you could probably just keep your eyes open as you travel and find a full set along the roadways in the ditches in a short time! These things seem to be notorious for falling...
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 05-27-2015, 05:07 PM
Replies: 19
Views: 666
Posted By donnor
Suckin' it up...

Have you checked for proper functioning of your vacuum pump?
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 05-26-2015, 10:18 PM
Replies: 7
Views: 526
Posted By donnor
The GEM is no gem...

Better translation for the GEM is Get an Earlier Model; ie a vehicle without this infernal creation whose untimely failures bring a smile to Satan's face. We experienced just such a failure on our...
Forum: 1978 - 1996 Big Bronco 03-29-2015, 01:06 PM
Replies: 655
Views: 102,537
Posted By donnor
Perseverance and Perspiration...

I have read your entire thread and commend you for seeing such a great undertaking through to this point. Congrats, enjoy, and later this spring when my wife and I are out there for a convention...
Forum: 1978 - 1996 Big Bronco 03-28-2015, 06:59 PM
Replies: 10
Views: 2,255
Posted By donnor
Another breed of pony...

I like! So why did only our amigos to the south have access to these?
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 03-28-2015, 09:39 AM
Replies: 5
Views: 331
Posted By donnor
Super, Short, and Sweet...

F250 Super Cab short beds [OBS] were available in 1996 & 97 model years only with engine choices of 460 or Power Stroke diesel so they are a bit rare. Keep looking - you will find one and, from what...
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 03-27-2015, 08:35 PM
Replies: 6
Views: 607
Posted By donnor
No respect in retrospect

... and very little to no factory support by now.

dn.
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 02-10-2015, 10:19 AM
Replies: 18
Views: 874
Posted By donnor
pivot bushing replacement

I second the motion of just disassemble the whole front end. Not only does it make the bushing replacement easier you are able to check out all other components of your front suspension to repair or...
Showing results 1 to 15 of 499

 
Forum Jump
 


All times are GMT -5. The time now is 11:50 PM.

 

Advertising - Terms of Use - Privacy Statement - Terms of Service - Jobs
This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. FordŽ is a registered trademark of the Ford Motor Company.

vbulletin Admin Backup