Ford Truck Enthusiasts Forums - Search Results
 

Go Back   Ford Truck Enthusiasts Forums > Search Forums
Log In 


Showing results 1 to 15 of 500
Search took 0.40 seconds.
Search: Posts Made By: Kemicalburns
Forum: Engine Swaps 02-08-2016, 02:47 PM
Replies: 4
Views: 98
Posted By Kemicalburns
what year hiboy is this going into? I had a 73...

what year hiboy is this going into? I had a 73 hiboy with a 300-6 and later a 390 backed to an np435.

I actually regret going with the 390 and should have stayed with the 300. granted my 390 was...
Forum: Engine Swaps 02-08-2016, 02:40 PM
Replies: 3
Views: 317
Posted By Kemicalburns
carbed or EFI?

carbed or EFI?
Forum: Engine Swaps 02-08-2016, 02:34 PM
Replies: 2
Views: 85
Posted By Kemicalburns
tuned yes, you will just run the 302 harness and...

tuned yes, you will just run the 302 harness and computer on the 5.8

you will obviously need the proper 5.8/trans flexplate or flywheel depending on your trans. DO NOT USE THE 5.0...
Forum: Engine Swaps 02-08-2016, 02:26 PM
Replies: 4
Views: 98
Posted By Kemicalburns
you will need different frame mounts, 4wd oil pan...

you will need different frame mounts, 4wd oil pan and a different bell houseing as well. I assume the 300 is bolted up to a manual trans correct?

the FE360/390 was offered in 73-76 for sure in a...
Forum: Engine Swaps 02-08-2016, 02:23 PM
Replies: 17
Views: 435
Posted By Kemicalburns
why do that though? the fender mounted ICM is the...

why do that though? the fender mounted ICM is the better solution.
Forum: Small Block V8 (221, 260, 289, 5.0/302, 5.8/351W) 02-08-2016, 02:21 PM
Replies: 6
Views: 134
Posted By Kemicalburns
Pull codes

Pull codes
Forum: 6.0L Power Stroke Diesel 02-04-2016, 01:40 PM
Replies: 7
Views: 221
Posted By Kemicalburns
thanks for the feedback fellas. I will get an...

thanks for the feedback fellas. I will get an update after this weekends inspection.
Forum: 6.0L Power Stroke Diesel 02-04-2016, 11:02 AM
Replies: 7
Views: 221
Posted By Kemicalburns
I noticed this morning a slight pop sound while...

I noticed this morning a slight pop sound while applying the breaks on the driver side. does this typically point to bad Ball Joints. I am only 9 months into my 2 year Ford premium warranty on this...
Forum: Small Block V8 (221, 260, 289, 5.0/302, 5.8/351W) 02-03-2016, 04:30 PM
Replies: 6
Views: 134
Posted By Kemicalburns
why are you replaceing the MAF sensor?

why are you replaceing the MAF sensor?
Forum: Small Block V8 (221, 260, 289, 5.0/302, 5.8/351W) 02-03-2016, 04:30 PM
Replies: 6
Views: 134
Posted By Kemicalburns
you will loose some fluid. when was the last time...

you will loose some fluid. when was the last time the trans was serviced? Perhaps this would be a good time.
Forum: 6.0L Power Stroke Diesel 02-03-2016, 01:05 PM
Replies: 7
Views: 221
Posted By Kemicalburns
I will inspect the front end this weekend and...

I will inspect the front end this weekend and hopefully be able to pinpoint the issue spots. the level kit on here is simply a puck and possibly newer shocks. I have been thinking about going to a...
Forum: 6.0L Power Stroke Diesel 02-01-2016, 06:27 PM
Replies: 7
Views: 221
Posted By Kemicalburns
Jarring ride

so i just recently went on a 100mile round trip drive and experienced the truck damn near leaping into another lane. This occured a couple times when i would hit a pot hole or in the first case a...
Forum: Engine Swaps 02-01-2016, 03:43 PM
Replies: 1
Views: 122
Posted By Kemicalburns
best way is to find the same year truck, F250...

best way is to find the same year truck, F250 with the motor/trans you want. there is much you will need to swap.

drive shaft, trans crossmember, efi wiring harness, motor mounts, exhaust etc..
Forum: Small Block V8 (221, 260, 289, 5.0/302, 5.8/351W) 02-01-2016, 03:39 PM
Replies: 6
Views: 134
Posted By Kemicalburns
pull the codes. Also pull the trans pan to make...

pull the codes. Also pull the trans pan to make sure the filter hasnt dropped.
Forum: 6.0L Power Stroke Diesel 01-29-2016, 02:21 PM
Replies: 18
Views: 559
Posted By Kemicalburns
Texas Bob, when i look up your alternator on...

Texas Bob, when i look up your alternator on Amazon it says that it doesnt fit my 2007 ford superduty.

i also dont see where it shows the output being 140amp.

Disregard, i read some of the...
Showing results 1 to 15 of 500

 
Forum Jump
 


All times are GMT -5. The time now is 08:16 AM.

 

Advertising - Terms of Use - Privacy Statement - Terms of Service - Jobs
This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. FordŽ is a registered trademark of the Ford Motor Company.

vbulletin Admin Backup