Ford Truck Enthusiasts Forums - Search Results
 

Go Back   Ford Truck Enthusiasts Forums > Search Forums
Log In 


Showing results 1 to 15 of 500
Search took 0.30 seconds.
Search: Posts Made By: Ken Blythen
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 02-09-2016, 02:19 AM
Replies: 6
Views: 172
Posted By Ken Blythen
Hi Jake.......I replaced my bushings a few years...

Hi Jake.......I replaced my bushings a few years ago (also a 2WD) & I took the coils right out.

I can't exactly remember why that was now, but probably because it was too difficult to push/pull...
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 02-07-2016, 02:44 AM
Replies: 15
Views: 463
Posted By Ken Blythen
Replacing or repairing the cross-shaft will fix...

Replacing or repairing the cross-shaft will fix both these problems, (you will still need to adjust the pedal freeplay). Welded properly, the tube would be fine, if it's not rusted out.

Was the...
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 02-05-2016, 01:56 PM
Replies: 38
Views: 710
Posted By Ken Blythen
Which would effectively give you a C6. I've...

Which would effectively give you a C6.

I've had both in one truck and didn't see any difference in power consumption (or mileage if not using OD), so it would be interesting to know what...
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 01-30-2016, 04:55 AM
Replies: 10
Views: 263
Posted By Ken Blythen
For the wiper knob - on the lower, front edge of...

For the wiper knob - on the lower, front edge of the knob (nearest the dash) is a notch; if you put a very small screwdriver, or a wire hook, in line with that notch & pull rearwards, reaching...
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 01-29-2016, 10:39 PM
Replies: 9
Views: 309
Posted By Ken Blythen
OK....thanks for the replies!

OK....thanks for the replies!
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 01-29-2016, 02:07 AM
Replies: 12
Views: 287
Posted By Ken Blythen
I think 7-8 years ago for the C6 version (AOD...

I think 7-8 years ago for the C6 version (AOD ones were more expensive). What about a scrap yard?
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 01-29-2016, 02:04 AM
Replies: 9
Views: 309
Posted By Ken Blythen
Camper shell interchangability

I've been watching out for a camper shell for a while, & one from a 92-96 truck has come up for sale locally.

Will these later shells swap directly onto 80-86 beds (in my case, '83) & seal OK?
...
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 01-28-2016, 01:12 AM
Replies: 12
Views: 287
Posted By Ken Blythen
If yours isn't repairable, LMC have the whole...

If yours isn't repairable, LMC have the whole unit.........Item 4


Truck Parts and Truck Accessories (http://www.lmctruck.com/icatalog/FD/full.aspx?Page=34)


A few years ago they had them for...
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 01-27-2016, 12:50 PM
Replies: 17
Views: 327
Posted By Ken Blythen
Is the thermostat good? If the engine...

Is the thermostat good?

If the engine isn't getting up to & holding operating temperature, it won't burn off moisture & contaminants in the oil, even if the PCV system is good.
You will also...
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 01-22-2016, 02:31 AM
Replies: 25
Views: 544
Posted By Ken Blythen
I don't particularly recommend LMC, but they do...

I don't particularly recommend LMC, but they do have the two intake hoses (hot & cold) for your air cleaner...........Truck Parts and Truck Accessories...
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 01-20-2016, 03:38 AM
Replies: 26
Views: 952
Posted By Ken Blythen
That's what it is. I had the same issue on the...

That's what it is. I had the same issue on the drivers side of my truck above about 30 mph........replaced the blades (more than once), no change; swapped arms from side to side, no change; replaced...
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 01-20-2016, 03:18 AM
Replies: 3
Views: 146
Posted By Ken Blythen
I don't know what the exact differences are...

I don't know what the exact differences are Brandon......but Rockauto doesn't show any radiators that fit both '82 & '92 351W truck's either.
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 01-16-2016, 03:04 PM
Replies: 14
Views: 304
Posted By Ken Blythen
Something's not what it seems

Something's not what it seems
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 01-10-2016, 03:44 AM
Replies: 2
Views: 148
Posted By Ken Blythen
If they are allowing you to lock the wiper arms...

If they are allowing you to lock the wiper arms in the lifted position (up off the windscreen), that is as much as they need to move.........but the arms get pretty stuck on the shaft splines at...
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 01-08-2016, 04:02 PM
Replies: 1
Views: 141
Posted By Ken Blythen
SAE 90 (or 80w/90 etc) gear oil.......best not to...

SAE 90 (or 80w/90 etc) gear oil.......best not to go higher than GL4 spec
Showing results 1 to 15 of 500

 
Forum Jump
 


All times are GMT -5. The time now is 08:15 AM.

 

Advertising - Terms of Use - Privacy Statement - Terms of Service - Jobs
This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. FordŽ is a registered trademark of the Ford Motor Company.

vbulletin Admin Backup