Ford Truck Enthusiasts Forums - Search Results
 

Go Back   Ford Truck Enthusiasts Forums > Search Forums
Log In 


Showing results 1 to 15 of 423
Search took 0.10 seconds.
Search: Posts Made By: carguy94
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 09-01-2015, 06:07 PM
Replies: 106
Views: 3,853
Posted By carguy94
Not sure about starter combinations but I know...

Not sure about starter combinations but I know from dealing with many gm products the only way to know how well the starter fits is to put some dye or paint on the Bendix gear and re install the...
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 08-24-2015, 03:56 PM
Replies: 106
Views: 3,853
Posted By carguy94
Glad to hear you got your truck all fixed up. I...

Glad to hear you got your truck all fixed up. I don't have info on labor times but wanted to say thanks for keeping us all updated on your progess . sounds like you have a real nice truck on your...
Forum: Fuel Injection, Carburetion & Fuel System 08-16-2015, 09:11 PM
Replies: 7
Views: 319
Posted By carguy94
Have you done an electrical check on the pump to...

Have you done an electrical check on the pump to be sure their is no resistance at the pump or its circuit. If theirs no blockage or pick up issue then it only leaves the pump circuit the pump or a...
Forum: 1997 - 2003 F150 08-14-2015, 09:36 PM
Replies: 13
Views: 356
Posted By carguy94
For a start you can check for spark and injection...

For a start you can check for spark and injection pulse. Do you have a inline spark tester and a test light a volt meter could help if you don't have a light. What you want to do is find out what's...
Forum: 1997 - 2003 F150 08-14-2015, 04:49 AM
Replies: 13
Views: 356
Posted By carguy94
You should not have to change the oil unless it...

You should not have to change the oil unless it had a fair amount off gas in it. Did you actually see cylinder 2 misfire. Sorry if I miss understood but is the cell and misfire code still there. A...
Forum: Fuel Injection, Carburetion & Fuel System 08-13-2015, 11:31 PM
Replies: 7
Views: 319
Posted By carguy94
As a starting point you need to know fuel...

As a starting point you need to know fuel pressure also consider that to big or different size fuel lines will cause this same issue. I see this is a 4 to 6 psi pump so i take it that it has a...
Forum: 1997 - 2003 F150 08-13-2015, 11:14 PM
Replies: 13
Views: 356
Posted By carguy94
Are all of their trouble codes gone. It usually...

Are all of their trouble codes gone. It usually takes a good while for the lean exhaust codes to come back if the fault is still present so it may take some driving. Also a lot of times after a lean...
Forum: 1997 - 2003 F150 06-18-2015, 04:28 PM
Replies: 7
Views: 364
Posted By carguy94
since your truck is a 97 it does not have the...

since your truck is a 97 it does not have the hybrid cluster like the 99 to 03 trucks do so you could unplug it and the truck will still run. same thing with the anti theft its a separate module on...
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 06-10-2015, 06:16 PM
Replies: 6
Views: 259
Posted By carguy94
The battery light is an idiot light and as far as...

The battery light is an idiot light and as far as it coming on for a bad ground it wont if the alternator works because it does not care about random power or ground points as long as the lights...
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 06-09-2015, 07:24 AM
Replies: 6
Views: 259
Posted By carguy94
just checking voltage at idle does not tell you...

just checking voltage at idle does not tell you much beings you got a normal readings. use the trucks accessories to load the system. turn your lights on bright flashers and so on to give it...
Forum: 2004 - 2008 F150 06-09-2015, 05:39 AM
Replies: 19
Views: 764
Posted By carguy94
The pcm may be fried but why did it fry? you need...

The pcm may be fried but why did it fry? you need to find and fix that because the same thing will happen again if you do not. where are you loosing grounds because if its an input then the PCM can...
Forum: 2004 - 2008 F150 06-05-2015, 11:12 AM
Replies: 19
Views: 764
Posted By carguy94
thats good how did you determine it was bad. i...

thats good how did you determine it was bad. i had mis took your post about jumping the relay i was assuming you were jumping the switched crank feed to the starter but you were actually jumping the...
Forum: 2004 - 2008 F150 06-04-2015, 11:01 PM
Replies: 3
Views: 297
Posted By carguy94
That does make a difference have you checked the...

That does make a difference have you checked the fluid and type. sounds like an internal issue did the shop that overhauled the trani do a line pressure check? how did you check the codes as typical...
Forum: 2004 - 2008 F150 06-04-2015, 10:35 PM
Replies: 19
Views: 764
Posted By carguy94
sorry been adding to my post accidentally deleted...

sorry been adding to my post accidentally deleted it. try swapping a know good relay with the one you jumped out. also use you volt meter and ground one lead and lightly touch the pin in the relay...
Forum: 2004 - 2008 F150 06-04-2015, 10:13 PM
Replies: 19
Views: 764
Posted By carguy94
Ha ha don't shoot yet i know how you feel though....

Ha ha don't shoot yet i know how you feel though. sounds like your not getting power to turn on the solenoid did you check to see if it had any juice. check for power in and out of the dtr sensor...
Showing results 1 to 15 of 423

 
Forum Jump
 


All times are GMT -5. The time now is 04:05 AM.

 

Powered by vBulletin® Version 3.8.7 AC2
Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.
Advertising - Terms of Use - Privacy Statement - Terms of Service - Jobs
This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. FordŽ is a registered trademark of the Ford Motor Company.

vbulletin Admin Backup