Ford Truck Enthusiasts Forums - Search Results
 

Go Back   Ford Truck Enthusiasts Forums > Search Forums
Log In 


Showing results 1 to 15 of 332
Search took 0.18 seconds.
Search: Posts Made By: BAD RONALD
Forum: Expedition & Navigator 08-05-2015, 08:20 AM
Replies: 31
Views: 970
Posted By BAD RONALD
Good thing you saved all that cash buying cheaper...

Good thing you saved all that cash buying cheaper bolts.
Forum: Aerostar 07-27-2015, 11:25 AM
Replies: 10
Views: 343
Posted By BAD RONALD
A "simple drop pan and change filter and change...

A "simple drop pan and change filter and change my fluid" isn't a transmission fluid change. You are asking about a different procedure.

As far as how many quarts you'll need for what you're...
Forum: Expedition & Navigator 07-24-2015, 12:26 PM
Replies: 31
Views: 970
Posted By BAD RONALD
Box end goes on the bolt, steel cheater pipe goes...

Box end goes on the bolt, steel cheater pipe goes over the wrench, pipe goes to the garage floor, torque wrench goes on the nut, super human strength goes on the torque wrench.
Forum: Aerostar 07-22-2015, 11:26 AM
Replies: 1
Views: 165
Posted By BAD RONALD
Most of the information posted on the...

Most of the information posted on the transmission forum here is pointing towards a busted reverse band and tranny overhaul. Sadly, I just don't see myself putting real money into this van.
Good...
Forum: Aerostar 07-20-2015, 01:53 PM
Replies: 1
Views: 165
Posted By BAD RONALD
No reverse

1995 2wd Aerostar 4.0l w/ 164,500 mi will not move in Reverse. Transmission is locked in Drive and otherwise operates normally. The van can only be pushed backwards when the engine is off. It can be...
Forum: Expedition & Navigator 07-07-2015, 06:01 PM
Replies: 2
Views: 170
Posted By BAD RONALD
surething just remove the rotors and pads.

surething just remove the rotors and pads.
Forum: Expedition & Navigator 07-06-2015, 10:17 AM
Replies: 8
Views: 917
Posted By BAD RONALD
Almost two years later, a misfire code appeared...

Almost two years later, a misfire code appeared for cylinder 2. Thanked myself today for buying the Ebay 10 pack of COPs then.

Went back in and retried all suggestions in this thread without being...
Forum: Expedition & Navigator 05-21-2015, 06:02 AM
Replies: 16
Views: 442
Posted By BAD RONALD
This is one way: HeaterTreater...

This is one way:

HeaterTreater (http://www.heatertreater.net/)

Video section will illustrate the repair for you.
Forum: Expedition & Navigator 05-06-2015, 08:57 AM
Replies: 14
Views: 274
Posted By BAD RONALD
Had a similar problem with a '11 Edge. The...

Had a similar problem with a '11 Edge. The difference was that the drain tube on the Edge was blocked south of the connection instead of detached. I attempted to snake a wire to clear the obstruction...
Forum: Expedition & Navigator 04-29-2015, 07:08 AM
Replies: 16
Views: 328
Posted By BAD RONALD
If my Expedition was getting 99.9 mpg, the last...

If my Expedition was getting 99.9 mpg, the last thing I would do is try and fix it.
Forum: Expedition & Navigator 03-29-2015, 04:06 PM
Replies: 10
Views: 435
Posted By BAD RONALD
You can say that again. I felt obliged to email...

You can say that again. I felt obliged to email the guy after the job to thank him.
Forum: Expedition & Navigator 03-29-2015, 09:51 AM
Replies: 10
Views: 435
Posted By BAD RONALD
https://sites.google.com/site/fordf150p0171p0174fi...

https://sites.google.com/site/fordf150p0171p0174fix/4r70w-fluid-change-procedures
Forum: Expedition & Navigator 03-15-2015, 08:48 AM
Replies: 31
Views: 970
Posted By BAD RONALD
A sawzall with a quality heavy duty 18 TPI blade...

A sawzall with a quality heavy duty 18 TPI blade will do. Buy the best blade you can find/afford.
Forum: Expedition & Navigator 03-14-2015, 11:04 AM
Replies: 6
Views: 416
Posted By BAD RONALD
This truck musta been running GREAT...no wonder...

This truck musta been running GREAT...no wonder you were tuning it up.
Forum: Expedition & Navigator 03-08-2015, 07:20 AM
Replies: 31
Views: 970
Posted By BAD RONALD
I replaced the failed original trailing arms on...

I replaced the failed original trailing arms on my '01 with the ones from PMT Fabrications. The product is a big improvement over OEM. I have basic knowledge of how to use tools and was able to do...
Showing results 1 to 15 of 332

 
Forum Jump
 


All times are GMT -5. The time now is 12:21 PM.

 

Powered by vBulletin® Version 3.8.7 AC2
Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.
Advertising - Terms of Use - Privacy Statement - Terms of Service - Jobs
This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. FordŽ is a registered trademark of the Ford Motor Company.

vbulletin Admin Backup