Ford Truck Enthusiasts Forums - Search Results
 

Go Back   Ford Truck Enthusiasts Forums > Search Forums
Log In 


Showing results 1 to 15 of 498
Search took 0.69 seconds.
Search: Posts Made By: ArdWrknTrk
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks Today, 05:53 AM
Replies: 3
Views: 106
Posted By ArdWrknTrk
Bill (Numberdummy) made this post in reply to a...

Bill (Numberdummy) made this post in reply to a question I asked about the resistance wire just yesterday.

http://www.ford-trucks.com/forums/1394728-460-cutting-out-popping.html#post15597826
Forum: 1987 - 1996 F150 & Larger F-Series Trucks Yesterday, 05:07 PM
Replies: 7
Views: 264
Posted By ArdWrknTrk
It's polyurethane foam. There's nothing to...

It's polyurethane foam.
There's nothing to dissolve it once it has hardened.

Scrape it out and use a wire wheel to clean the metal.
Fix the leak, fix the corner, prime and paint.

I'm using...
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks Yesterday, 12:38 PM
Replies: 5
Views: 168
Posted By ArdWrknTrk
I have my doubts, but there's a recommendation...

I have my doubts, but there's a recommendation down in the exhaust forum

http://www.ford-trucks.com/forums/1392725-temp-fix-on-a-cracked-manifold.html
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks Yesterday, 12:24 PM
Replies: 12
Views: 198
Posted By ArdWrknTrk
Check the resistance between the coil primary...

Check the resistance between the coil primary feed and the red (run) wire going to your module.
Check this against the white wire in the same plug, which should be zero Ohms, or close to it.....
...
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 08-26-2015, 11:34 PM
Replies: 146
Views: 3,142
Posted By ArdWrknTrk
PA Performance makes the fake regulator box for...

PA Performance makes the fake regulator box for swapping a 1G to 3G.
The problem with using a 95A (small case) to deliver more that 100A -except for a short surge- is that the heatsink and fans are...
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 08-26-2015, 06:28 PM
Replies: 12
Views: 198
Posted By ArdWrknTrk
Why would it fail in 6,000 miles? Is there a...

Why would it fail in 6,000 miles?

Is there a resistor wire in the run circuit?
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 08-26-2015, 11:33 AM
Replies: 12
Views: 198
Posted By ArdWrknTrk
The DSII pickup inside the distributor should...

The DSII pickup inside the distributor should read between 450-950 ohms across the orange and purple wires of the distributor connector.
While you're at it check the black wire to ground as you work...
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 08-26-2015, 04:39 AM
Replies: 31
Views: 494
Posted By ArdWrknTrk
You are reading the engineering number, not the...

You are reading the engineering number, not the part number.
if it came from a 460 truck you have the right part.

This is a 351M/400 bell housing and you will have a problem with pressure plate...
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 08-25-2015, 09:18 PM
Replies: 31
Views: 494
Posted By ArdWrknTrk
No more or less headache. If you are happy with...

No more or less headache.
If you are happy with the T-18 you have why spend the $$$ on somebody else's used parts?

Your link doesn't work for me.
I've had good luck with Luk and Sachs clutches...
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 08-25-2015, 07:36 PM
Replies: 6
Views: 111
Posted By ArdWrknTrk
I use Tabco. They have the B-pillar corner for...

I use Tabco.
They have the B-pillar corner for 80-86 trucks.

https://tabcoparts.com/pickup-trucks/ford/pickup-bronco-1980-1998.html
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 08-25-2015, 07:22 PM
Replies: 31
Views: 494
Posted By ArdWrknTrk
T-18's have a single PTO window on the passenger...

T-18's have a single PTO window on the passenger side and no synchro for first gear.
Where the T-19 found behind 460's have PTO on both sides and is fully synchronized.

Lots of people make a...
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 08-25-2015, 12:51 PM
Replies: 31
Views: 494
Posted By ArdWrknTrk
You need to get a clutch *kit* and flywheel for a...

You need to get a clutch *kit* and flywheel for a '83-'86 460 truck.
The kit should include a pilot bearing for the end of the crankshaft and a release bearing to fit in the fork of the throwout...
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 08-25-2015, 08:49 AM
Replies: 19
Views: 581
Posted By ArdWrknTrk
Sorry, nvm Stupid reply to thread from...

Sorry, nvm
Stupid reply to thread from mobile....
Why does IB need to "feature" scrolling directly to (related) threads???
Forum: Big Block V8 - 385 Series (6.1/370, 7.0/429, 7.5/460) 08-25-2015, 04:27 AM
Replies: 8
Views: 196
Posted By ArdWrknTrk
But that won't get fuel above the pistons and...

But that won't get fuel above the pistons and lock the engine.
Forum: Big Block V8 - 385 Series (6.1/370, 7.0/429, 7.5/460) 08-24-2015, 08:02 PM
Replies: 8
Views: 196
Posted By ArdWrknTrk
Check your oil level. If the cylinders have...

Check your oil level.
If the cylinders have been sitting full of gasoline you can bet the sump is full and the oil is diluted.

I had this happen with a brand new Holley carb, where two of the...
Showing results 1 to 15 of 498

 
Forum Jump
 


All times are GMT -5. The time now is 12:14 PM.

 

Powered by vBulletin® Version 3.8.7 AC2
Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.
Advertising - Terms of Use - Privacy Statement - Terms of Service - Jobs
This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. FordŽ is a registered trademark of the Ford Motor Company.

vbulletin Admin Backup