Ford Truck Enthusiasts Forums - Search Results
 

Go Back   Ford Truck Enthusiasts Forums > Search Forums
Log In 


Showing results 1 to 15 of 205
Search took 0.24 seconds.
Search: Posts Made By: Tumblindyce
Forum: 1957 - 1960 F100 & Larger F-Series Trucks 06-21-2015, 11:37 PM
Replies: 23
Views: 730
Posted By Tumblindyce
Wally, you may well have seen the red and white...

Wally, you may well have seen the red and white 60 in Pahrump, but she's back East now. My brother owns her as of about 4 years ago.

I saw you this morning (Sunday, Father's Day). You were...
Forum: 1957 - 1960 F100 & Larger F-Series Trucks 06-11-2015, 10:44 PM
Replies: 23
Views: 730
Posted By Tumblindyce
Wow! I remember when you first started building...

Wow! I remember when you first started building Teddy! You did an amazing job!! That is one awesome truck--congratulations on a job well done!
Forum: 1957 - 1960 F100 & Larger F-Series Trucks 06-11-2015, 10:36 PM
Replies: 14
Views: 588
Posted By Tumblindyce
If those leads don't pan out, I can get originals...

If those leads don't pan out, I can get originals for sure. I'm not on here a lot anymore, but my email is Tumblindyce@gmail.com.
Forum: 1978 - 1996 Big Bronco 09-07-2014, 02:30 PM
Replies: 3
Views: 300
Posted By Tumblindyce
Thanks guys. I wound up using a Speedway master...

Thanks guys. I wound up using a Speedway master that I had in the garage. This was after pulling a line from the junkyard. I see why the junkyard was the recommended source too. Those lines aren't...
Forum: 1978 - 1996 Big Bronco 09-01-2014, 05:51 PM
Replies: 3
Views: 300
Posted By Tumblindyce
Clutch Master Question

Hi, I'm working on a 1969 Jeep CJ5 and I put a clutch master cylinder in it out of a 1989 Ford Bronco. What type of connection does the hydraulic line use? I don't see any threads in the female bore...
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 07-25-2014, 11:11 PM
Replies: 8
Views: 438
Posted By Tumblindyce
The new parts are in and the AC is blowing...

The new parts are in and the AC is blowing through the dash vents! I did have to cut the harness and crimp on some female connectors. Autozone had the male side of the blower switch.
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 07-25-2014, 11:02 PM
Replies: 43
Views: 1,788
Posted By Tumblindyce
Beep beep!! :-)

Beep beep!! :-)
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 07-23-2014, 12:48 AM
Replies: 43
Views: 1,788
Posted By Tumblindyce
Awesome story! Not a bad looking truck too...:-X22

Awesome story! Not a bad looking truck too...:-X22
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 07-22-2014, 02:00 AM
Replies: 8
Views: 438
Posted By Tumblindyce
I found the part on "wholesaler closeout" at Rock...

I found the part on "wholesaler closeout" at Rock Auto...cheap! It's called a heater blend door actuator, which makes perfect sense. Hope this helps someone else.

...
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 07-21-2014, 07:16 PM
Replies: 8
Views: 438
Posted By Tumblindyce
Looks like I found the problem. The harness...

Looks like I found the problem. The harness connection for the blower switch is fried!
...
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 07-21-2014, 06:25 PM
Replies: 8
Views: 438
Posted By Tumblindyce
OK, with key on test light indicates power in the...

OK, with key on test light indicates power in the pigtail connection to the blower motor. so I guess the next place to look is my 4 position switch in the dash?
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 07-21-2014, 05:48 PM
Replies: 8
Views: 438
Posted By Tumblindyce
Thanks Dan. I already pulled the resistors and...

Thanks Dan. I already pulled the resistors and they looked a little cruddy, but not really that bad. It's kinda hard to see how those things would even go bad, they're just coils of wire, but I guess...
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 07-21-2014, 04:52 PM
Replies: 8
Views: 438
Posted By Tumblindyce
New Guy

Hi, I've been lurking here a bit. I used to be on the 57-60 forum quite a bit, but the truck in my avatar has since been passed on to my brother. Anyway, I recently bought a 1989 F250. It's the light...
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 07-11-2014, 03:10 PM
Replies: 0
Views: 203
Posted By Tumblindyce
Rubber Flooring

Has anyone used this company's products?
1980-1986 Ford Full Size Truck, Standard Cab Molded Vinyl Flooring - 2 WD Floor Shift or 4 WD (High Tunnel)...
Forum: WTB - Ford Trucks & other vehicles 06-20-2013, 07:58 PM
Replies: 7
Views: 1,084
Posted By Tumblindyce
WTB: Old Pickup, Panel, Bus, etc...

...shorty bus, cab and chassis, milk truck?? Prefer Ford 1956 or older. Ford, Chevy, Jeep, International, Dodge, etc... body and title, unmolested builder only. Nothing restored...reasonably priced....
Showing results 1 to 15 of 205

 
Forum Jump
 


All times are GMT -5. The time now is 07:52 PM.

 

Powered by vBulletin® Version 3.8.7 AC2
Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.
Advertising - Terms of Use - Privacy Statement - Terms of Service - Jobs
This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. Ford® is a registered trademark of the Ford Motor Company.

vbulletin Admin Backup