Ford Truck Enthusiasts Forums - Search Results
 

Go Back   Ford Truck Enthusiasts Forums > Search Forums
Log In 


Showing results 1 to 15 of 488
Search took 0.39 seconds.
Search: Posts Made By: j.grif
Forum: 2009 - 2014 F150 Yesterday, 12:57 AM
Replies: 18
Views: 517
Posted By j.grif
That's just gorgeous!

That's just gorgeous!
Forum: 2009 - 2014 F150 07-29-2015, 12:10 AM
Replies: 7
Views: 278
Posted By j.grif
What border city are you talking about, in the...

What border city are you talking about, in the Detroit area, I have seen two xtr series f150's in the last ten years!
Forum: 2009 - 2014 F150 07-26-2015, 04:51 PM
Replies: 119
Views: 7,169
Posted By j.grif
You broke no.1 rule, don't add up the tickets if...

You broke no.1 rule, don't add up the tickets if you are having fun! Great thread!
Forum: 2009 - 2014 F150 07-26-2015, 10:23 AM
Replies: 20
Read First: Discuss the EcoBoost!
Views: 870
Posted By j.grif
It could be any of the above, it could also be...

It could be any of the above, it could also be contamination from fuel dilution, diluted fuel lowers viscosity and shear protection, used oil analysis show on my engine 5% dilution at drain cycles of...
Forum: 2009 - 2014 F150 07-26-2015, 09:51 AM
Replies: 20
Read First: Discuss the EcoBoost!
Views: 870
Posted By j.grif
so, about those quick drain valves you all were...

so, about those quick drain valves you all were talking about!
Forum: 2009 - 2014 F150 07-25-2015, 11:42 PM
Replies: 20
Read First: Discuss the EcoBoost!
Views: 870
Posted By j.grif
I think that when the lower end bearings and the...

I think that when the lower end bearings and the cam wear surfaces wear you lose oil pressure, the tensioners are controlled with oil pressure, that is the only connection that I try to make, on the...
Forum: 2009 - 2014 F150 07-25-2015, 05:31 PM
Replies: 20
Read First: Discuss the EcoBoost!
Views: 870
Posted By j.grif
Can you imagine the amount of bearing wear in...

Can you imagine the amount of bearing wear in either the mains or the cam journals that would allow the chains to be jumping all over the place, I think this is a lubrication problem from the...
Forum: 2015+ F150 07-19-2015, 11:14 AM
Replies: 42
Views: 2,129
Posted By j.grif
As much as I would like to buy a new 2015, common...

As much as I would like to buy a new 2015, common sense tells me I need to save for rainy days and retirement, my 2012 has 37,000 miles on it and does what I need it to do!
Forum: Brakes, Steering, Suspension, Tires, & Wheels 07-18-2015, 11:57 PM
Replies: 3
Views: 225
Posted By j.grif
X2 on the good year duratracs, both shop/plow...

X2 on the good year duratracs, both shop/plow trucks running them on 3/4 ton, super good traction, look aggressive as h*ll and are fairly quiet, boss man says good wear as well.
Forum: 2009 - 2014 F150 07-14-2015, 10:54 AM
Replies: 82
Views: 4,067
Posted By j.grif
I have said it before and I will say it again, my...

I have said it before and I will say it again, my 5.4 2006 fx4 would average 13.5, on long freeway trips it would get 15.7 hand calculated and was tough truck to tow with, it had 3.55 gears and was...
Forum: 2009 - 2014 F150 06-29-2015, 12:02 AM
Replies: 7
Views: 458
Posted By j.grif
I had a similar experience with a large local...

I had a similar experience with a large local chain tire discounter, it did not end as well for me, will never shop there again, they did not make it right, trouble is, when these kids working on...
Forum: 2004 - 2008 F150 06-26-2015, 01:02 AM
Replies: 5
Views: 469
Posted By j.grif
I have a few questions, when you took the old...

I have a few questions, when you took the old plugs out, did you blow around them with a blow gun and compressed air? How did the old plugs come out, easy or hard? When you put the plugs back in, did...
Forum: 2009 - 2014 F150 05-29-2015, 11:45 PM
Replies: 11
Views: 399
Posted By j.grif
I would suspect that they would install direct or...

I would suspect that they would install direct or very close to direct, that cab changed very little, I think the same cab from 04 to 2014, you may have to install nutserts in the a pillar where the...
Forum: 2009 - 2014 F150 05-25-2015, 10:45 PM
Replies: 2
Views: 255
Posted By j.grif
My guess is that you are looking at a fuse, clear...

My guess is that you are looking at a fuse, clear top, you should see an unbroken band of metal, that should just pull out, I would get a service manual and study the wiring diagrams of this circuit,...
Forum: EcoBoost (all engine sizes) 05-17-2015, 11:06 PM
Replies: 8
Views: 1,158
Posted By j.grif
I looked at a 2011 in my local neighborhood just...

I looked at a 2011 in my local neighborhood just out of curiosity, the guy wants 13,000 for it, says it has 198,000 miles on it truck looked pretty good to me, of course, I have no knowledge of what...
Showing results 1 to 15 of 488

 
Forum Jump
 


All times are GMT -5. The time now is 12:06 AM.

 

Powered by vBulletin® Version 3.8.7 AC2
Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.
Advertising - Terms of Use - Privacy Statement - Terms of Service - Jobs
This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. FordŽ is a registered trademark of the Ford Motor Company.

vbulletin Admin Backup