Go Back   Ford Truck Enthusiasts Forums > Search Forums
Sign in using an external account
Register Forgot Password?


Showing results 1 to 15 of 499
Search took 0.58 seconds.
Search: Posts Made By: Fishin76
Forum: Super Duty & Heavy Duty Today, 06:32 AM
Replies: 3
Views: 155
Posted By Fishin76
If you plan on getting a Trans, then rebuilding...

If you plan on getting a Trans, then rebuilding it, I would get one from a 6.8L truck. It will already have the 6 pinion steel planetaries, and a 4 pinion OD planetary. 5.4L trans only have 4...
Forum: Super Duty & Heavy Duty Today, 06:24 AM
Replies: 5
Views: 108
Posted By Fishin76
For one, 08's never came with a 6.0. If a swap...

For one, 08's never came with a 6.0. If a swap was possible, you would be looking at a 6.4L. Then there the trans, and wiring, and dash, and ... and... and....

Much easier to trade trucks to...
Forum: Super Duty & Heavy Duty 04-24-2015, 12:46 PM
Replies: 43
Views: 1,850
Posted By Fishin76
All back together now, working absolutely...

All back together now, working absolutely normal.. (with the exception of the shift kit and the low stall converter. thats just the icing on the cake.)

Noise I had with the last converter is no...
Forum: 2004 - 2008 F150 04-24-2015, 11:22 AM
Replies: 362
Views: 234,262
Posted By Fishin76
It should have been something they tested. after...

It should have been something they tested. after not finding a leak any other place.
Forum: Clutch, Transmission, Differential, Axle & Transfer Case 04-24-2015, 11:08 AM
Replies: 536
Views: 92,437
Posted By Fishin76
Even more advice: put a new pump gears in,...

Even more advice:

put a new pump gears in, IMHO not negotiable. they are too cheap not to just replace them.

Make sure you torque everything to spec. Under torque will allow crossleaks,...
Forum: Super Duty & Heavy Duty 04-24-2015, 06:02 AM
Replies: 7
Views: 226
Posted By Fishin76
Just so your informed, A new solenoid pack takes...

Just so your informed, A new solenoid pack takes about 40 minutes to change out. (in the driveway, no lift)

Drain tranny pan,
lower the pan
diconnect wiring harness from right side of trans...
Forum: Super Duty & Heavy Duty 04-23-2015, 07:44 AM
Replies: 12
Views: 463
Posted By Fishin76
GCWR - GVWR = Trailer weight rating. In...

GCWR - GVWR = Trailer weight rating.

In your case.

'07 F250 V10 CC 4x4 GCWR is 22.5k GVWR is 9.6k

So that means your rated for 12.9K of trailer weight. (a little less if your...
Forum: Super Duty & Heavy Duty 04-23-2015, 07:09 AM
Replies: 3
Views: 178
Posted By Fishin76
33"s with a stock 7.3 and 3.73's will keep your...

33"s with a stock 7.3 and 3.73's will keep your acceleration adequate. much bigger, and it will seem slow, and harder to stop due to the rolling mass of the tires..

Keep in mind, you will lose...
Forum: Super Duty & Heavy Duty 04-21-2015, 01:17 PM
Replies: 43
Views: 1,850
Posted By Fishin76
Pittsburg 3/8" torque wrench. from HF. ...

Pittsburg 3/8" torque wrench. from HF.

Nice part is Lifetime Warranty and no questions, drop off broken one, pickup new one.. This is the first bad tool I have ever bought from HF. I...
Forum: Super Duty & Heavy Duty 04-21-2015, 10:45 AM
Replies: 43
Views: 1,850
Posted By Fishin76
as much as 50%..... and it wasn't that old. ...

as much as 50%..... and it wasn't that old. just a bad one..

It doesn't help to have a bad attitude, only makes it that much harder to concentrate on getting it done.

Do i want this...
Forum: Super Duty & Heavy Duty 04-21-2015, 10:04 AM
Replies: 43
Views: 1,850
Posted By Fishin76
Back at it again.

Torque converter went out.. It's back out of the truck again....

I have narrowed every failure except one, to a torque wrench faliure.

VB's, Pump bolts, pump-to-case, and torque converter...
Forum: Super Duty & Heavy Duty 04-17-2015, 07:59 PM
Replies: 18
Views: 557
Posted By Fishin76
:-jammin:-jammin:-jammin Good job!! i...

:-jammin:-jammin:-jammin


Good job!! i knew you could do it!!!
Forum: Super Duty & Heavy Duty 04-17-2015, 07:43 AM
Replies: 15
Views: 463
Posted By Fishin76
You are correct. Mark did mention that, but i...

You are correct. Mark did mention that, but i think it was in reference to 4r100's, Not sure if the internals of a 5r110W are different from Gas to diesel.

Gas 4r100's only have 4 pinion...
Forum: 2004 - 2008 F150 04-17-2015, 07:06 AM
Replies: 362
Views: 234,262
Posted By Fishin76
Yup, If you put it into 4wd, and the noise...

Yup, If you put it into 4wd, and the noise stops, you have a vacuum leak. It could very well be the actuators thenselves that are leaking. I only ever had one actuator go bad. When I got it...
Forum: Super Duty & Heavy Duty 04-17-2015, 06:30 AM
Replies: 18
Views: 557
Posted By Fishin76
I still say do it yourself, keep the $150 in...

I still say do it yourself, keep the $150 in labor money to start your savings toward a complete job. It's not hard. A cheap socket set and a breaker bar, your tire iron from under the hood, and...
Showing results 1 to 15 of 499

 
Forum Jump
 

Participate In The Forums

Create new posts and participate in discussions. It's free!

Sign Up »


All times are GMT -5. The time now is 07:33 AM.


Powered by vBulletin® Version 3.8.7 AC1
Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.
Advertising - Terms of Use - Privacy Statement - Terms of Service - Jobs
This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. Ford® is a registered trademark of the Ford Motor Company.

vbulletin Admin Backup