Go Back   Ford Truck Enthusiasts Forums > Search Forums
Sign in using an external account
Register Forgot Password?


Showing results 1 to 15 of 497
Search took 0.65 seconds.
Search: Posts Made By: pbeering
Forum: Super Duty & Heavy Duty 03-18-2015, 10:01 AM
Replies: 42
Views: 15,290
Posted By pbeering
Depends how you rig it. I would use a snatch...

Depends how you rig it. I would use a snatch block and tie off on the tow hook and some hard point straight ahead. You aren't pulling the whole weight like in a dead lift, but a lateral pull.

I...
Forum: Super Duty & Heavy Duty 03-18-2015, 09:28 AM
Replies: 42
Views: 15,290
Posted By pbeering
I bought a hitch extension and welded a piece of...

I bought a hitch extension and welded a piece of plate to it with a gusset for support. Then drilled the plate to match the holes in the tow hook mount. This assembly has been installed on the last...
Forum: Super Duty & Heavy Duty 12-08-2014, 05:45 AM
Replies: 7
Views: 511
Posted By pbeering
Run the heavier wire and check the rating on the...

Run the heavier wire and check the rating on the switch. I'd opt for a 30 amp switch or split the lights front/back.

Your design sounds good. Be sure you have this grounded to the battery to...
Forum: Super Duty & Heavy Duty 12-07-2014, 09:51 PM
Replies: 7
Views: 511
Posted By pbeering
Not sure how many of the LED work lights you...

Not sure how many of the LED work lights you have, but they should not draw enough to require a relay. If you didn't need one for your halogens, you won't need one for the LED's.
Forum: Transit Connect 09-04-2014, 06:38 AM
Replies: 2
Views: 535
Posted By pbeering
Most up fitters use the expanding bolt mounts to...

Most up fitters use the expanding bolt mounts to add hard points where needed. Requires an installation tool and a drill. The nut side expands to fit the hole like a Molly bolt.

There are a couple...
Forum: Transit Connect 04-11-2014, 07:50 PM
Replies: 3
Views: 727
Posted By pbeering
It is called a bulkhead or partition. There are a...

It is called a bulkhead or partition. There are a number of different types. Look at Adrian Steel and Ranger. There should be several up fitters in your area. Ask your dealer. They may be able to...
Forum: 6.7L Power Stroke Diesel 04-01-2014, 07:25 PM
Replies: 28
Views: 3,026
Posted By pbeering
I have standardized my fleet around Rigid. We use...

I have standardized my fleet around Rigid. We use the Dually D2 for task lighting, the 6" for rear work lights, and the 30" combo bar for front work lights.

Yes, they are expensive, but they...
Forum: 2014+ Transit 03-05-2014, 07:13 PM
Replies: 20
Views: 2,567
Posted By pbeering
There are a number of configurations of the new...

There are a number of configurations of the new Transits here in Indianapolis at NTEA. I sat in a big one fitted with a bulkhead and found it very roomy and not confining. I am 6'1". Sorry, no...
Forum: 2014+ Transit 03-03-2014, 07:02 PM
Replies: 20
Views: 2,567
Posted By pbeering
Not certain, but they typically bring one the the...

Not certain, but they typically bring one the the NTEA (National Truck Equipment Assoc.) show here in Indianapolis. Trade show is Wed-Fri downtown Indy Convention Center.
Forum: Audio & Video Systems, Navigation, Satellite Radio & Mobile Electronics 02-25-2014, 08:13 PM
Replies: 2
Views: 496
Posted By pbeering
It is probably easier to tap a lighted switch for...

It is probably easier to tap a lighted switch for this purpose than to disassemble the radio. Lot shorter wire run too.
Forum: Appearance & Dress-Up 12-31-2013, 08:16 PM
Replies: 3
Views: 337
Posted By pbeering
Use some white polishing compound on a washcloth....

Use some white polishing compound on a washcloth. Rub gently until it comes off. You can use soft scrub if white compound isn't available
Forum: Super Duty & Heavy Duty 12-31-2013, 08:07 PM
Replies: 5
Views: 701
Posted By pbeering
Surf to www.rvcams.com. Vision systems has...

Surf to www.rvcams.com. Vision systems has several small cameras that will work. I have used the small color camera in several applications with great success.
Forum: Super Duty & Heavy Duty 11-28-2013, 07:13 PM
Replies: 71
Views: 2,853
Posted By pbeering
Depends where it was used, what it plowed, and...

Depends where it was used, what it plowed, and how well it was maintained. These are work trucks and there is much mythology about plowing wear. (There is a percentage of the Superduty population who...
Forum: 6.7L Power Stroke Diesel 11-24-2013, 07:41 PM
Replies: 26
Views: 3,109
Posted By pbeering
The kit is pretty much plug and play. It has HID...

The kit is pretty much plug and play. It has HID low beams and halogen high beams. The rings on mine are CCFL. Not sure if they are LED now.

You won't use the high beams. I have used high beams a...
Forum: 6.7L Power Stroke Diesel 11-23-2013, 09:26 PM
Replies: 26
Views: 3,109
Posted By pbeering
Here is the thread on these lights installed on...

Here is the thread on these lights installed on my ''08 http://www.ford-trucks.com/forums/856779-08-hid-projector-installation.html#post7573766

10,000 Kelvin will be very blue and you will get...
Showing results 1 to 15 of 497

 
Forum Jump
 

Participate In The Forums

Create new posts and participate in discussions. It's free!

Sign Up »


All times are GMT -5. The time now is 04:47 PM.


Powered by vBulletin® Version 3.8.7 AC1
Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.
Advertising - Terms of Use - Privacy Statement - Terms of Service - Jobs
This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. Ford® is a registered trademark of the Ford Motor Company.

vbulletin Admin Backup