Go Back   Ford Truck Enthusiasts Forums > Search Forums
Sign in using an external account
Register Forgot Password?


Showing results 1 to 15 of 283
Search took 0.67 seconds.
Search: Posts Made By: tempforce
Forum: General Diesel Discussion 01-26-2015, 12:27 PM
Replies: 39
Views: 1,365
Posted By tempforce
lots of people are getting rid of oil and propane...

lots of people are getting rid of oil and propane tanks. just look for a nice clean one.. and make it into your storage tank. caution if you convert the propane tank. ensure the tank is filled with...
Forum: General Diesel Discussion 01-19-2015, 07:33 AM
Replies: 39
Views: 1,365
Posted By tempforce
go for it, just use a 10 micron filter/separator...

go for it, just use a 10 micron filter/separator before or after your transfer pump.
I've used a small 250 gallon fuel oil tank for years... for both the truck and tractor... if your afraid of...
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 11-22-2014, 03:50 PM
Replies: 50
Views: 1,115
Posted By tempforce
if your not getting circulation and the bottom of...

if your not getting circulation and the bottom of the radiator and lower hose is cold. the thermostat is closed or you have a collapsed hose. how long have you been running the engine...
if the...
Forum: 6.7L Power Stroke Diesel 11-22-2014, 03:32 PM
Replies: 27
Views: 1,753
Posted By tempforce
dually's need more traction on wet, icy...

dually's need more traction on wet, icy surfaces....
some gravel, bags of sand or a couple hundred lbs of concrete blocks will help.
another option is, to run without your inner tires...
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 11-22-2014, 03:19 PM
Replies: 65
Views: 1,842
Posted By tempforce
cardboard in front of grill or in front of a/c...

cardboard in front of grill or in front of a/c condenser. you need to leave some space for air, so you won't over heat.
use a block heater and or park inside to get a heat start on heat.
higher...
Forum: 1948 - 1956 F1, F100 & Larger F-Series Trucks 11-21-2014, 03:32 PM
Replies: 3
Views: 348
Posted By tempforce
truck part pricing

i need help. i have a few extra parts that i plan on sending to a new home.
what kind of value should i put on them.
below is a listing:
outer front fenders: minor dents and one with a split (4-5"...
Forum: 1948 - 1956 F1, F100 & Larger F-Series Trucks 11-20-2014, 04:09 PM
Replies: 7
Views: 397
Posted By tempforce
i have a factory seat that is in my '56' ...

i have a factory seat that is in my '56'
check the factory measurement's between the two years. to see if my seat will work for you.....
i'm about 50 miles se of you.
pm me, to get my e-mail...
Forum: 2015+ F150 11-18-2014, 09:51 AM
Replies: 79
Views: 9,485
Posted By tempforce
a bronco based upon the world ranger. with a...

a bronco based upon the world ranger. with a diesel engine option would be great for back roads and hunting. with additional options be made into a tough off road rig...
Forum: 1948 - 1956 F1, F100 & Larger F-Series Trucks 11-03-2014, 07:54 AM
Replies: 63
Views: 5,536
Posted By tempforce
personally i would go for isolated motor mounts....

personally i would go for isolated motor mounts. i would use neoprene, instead of rubber that flexes more.
the firmer the material the more engine vibration will transfer.
if you stress your...
Forum: 1948 - 1956 F1, F100 & Larger F-Series Trucks 09-15-2014, 09:15 AM
Replies: 30
Views: 1,508
Posted By tempforce
have front axle, springs and spindles. needs...

have front axle, springs and spindles. needs t.l.c. sandblasted, ect.
located in central texas
Forum: 1948 - 1956 F1, F100 & Larger F-Series Trucks 09-08-2014, 08:31 AM
Replies: 2
Views: 317
Posted By tempforce
bouncing speedo

time to replace the cable and housing.... it won't get better...
Forum: 1948 - 1956 F1, F100 & Larger F-Series Trucks 09-08-2014, 08:28 AM
Replies: 8
Views: 561
Posted By tempforce
type f or ???

the ford c-4 and c-6 came with type 'F' transmission fluid.
it gave the transmission firmer shifts and reduced band/clutch wear... using the dexron/mercron fluids will soften the shifts and with a...
Forum: 1961 - 1966 F-100 & Larger F-Series Trucks 08-24-2014, 10:53 PM
Replies: 48
Views: 2,522
Posted By tempforce
if you were in my area, i would have you deliver...

if you were in my area, i would have you deliver it to my shop. i would fix it for you... only cost would be for any items i had to buy or have done at another shop.. i.e.: valve grinding/seating......
Forum: 1948 - 1956 F1, F100 & Larger F-Series Trucks 08-21-2014, 10:07 PM
Replies: 56
Views: 2,946
Posted By tempforce
I would enjoy another get together. At least I...

I would enjoy another get together. At least I have a truck now...
I spent several hours today, building my new shop.
Hopefully late fall I'll be starting on the tear down of the 56.
Forum: 1948 - 1956 F1, F100 & Larger F-Series Trucks 08-18-2014, 11:09 PM
Replies: 56
Views: 2,946
Posted By tempforce
My workshop is going up, have a donor mark 8...

My workshop is going up, have a donor mark 8 sitting in the yard. Crown Vic front end waiting to be installed. As soon as the shops roof is up.
Is there going to be a get together this year???
Showing results 1 to 15 of 283

 
Forum Jump
 

Participate In The Forums

Create new posts and participate in discussions. It's free!

Sign Up »


All times are GMT -5. The time now is 02:43 PM.


Powered by vBulletin® Version 3.8.7 AC1
Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.
Advertising - Terms of Use - Privacy Statement - Jobs
This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. Ford® is a registered trademark of the Ford Motor Company.

vbulletin Admin Backup