Go Back   Ford Truck Enthusiasts Forums > Search Forums
Sign in using an external account
Register Forgot Password?


Showing results 1 to 15 of 488
Search took 0.16 seconds.
Search: Posts Made By: f5fordgirl
Forum: 1961 - 1966 F-100 & Larger F-Series Trucks 01-21-2015, 02:17 PM
Replies: 3
Views: 113
Posted By f5fordgirl
If you're talking about the inner axel splines,...

If you're talking about the inner axel splines, you can see how much wear they have, and compare it to a good one, that will give you some kinda idea.
Forum: 1961 - 1966 F-100 & Larger F-Series Trucks 01-21-2015, 02:13 PM
Replies: 10
Views: 321
Posted By f5fordgirl
My uncle said a guy had a ford V4 in an old skid...

My uncle said a guy had a ford V4 in an old skid loader, he said it looked like a 2.8 that was short 2 cyl's. He said it took the same bearing as the 2.8's did. You might check if the water pump is...
Forum: 2.6, 2.8, 2.9, 4.0 & SOHC 4.0 V6 01-21-2015, 08:02 AM
Replies: 3
Views: 630
Posted By f5fordgirl
Having pressure doesn't mean its the right...

Having pressure doesn't mean its the right amount, if it hits with either, but won't run, it sounds like the new regulator is bad.
Forum: Ranger & B-Series 01-17-2015, 10:58 AM
Replies: 18
Views: 352
Posted By f5fordgirl
Have you checked the level in the clutch master...

Have you checked the level in the clutch master cyl reservoir, if its empty, theres your problem. If it still has fluid, then either the slave, or master has gotten air in them. If its air in the...
Forum: Ranger & B-Series 01-13-2015, 07:03 PM
Replies: 5
Views: 166
Posted By f5fordgirl
I think they go in the back side of the hubs to...

I think they go in the back side of the hubs to keep the parts you have layed out, from falling out.
Forum: Ranger & B-Series 01-12-2015, 01:34 PM
Replies: 2
Views: 223
Posted By f5fordgirl
Could be a leaking wheel cyl. or axel seal, or...

Could be a leaking wheel cyl. or axel seal, or sticking emergency brake cable.
Forum: Ranger & B-Series 01-12-2015, 11:12 AM
Replies: 5
Views: 227
Posted By f5fordgirl
May want to pull the dist cap and check for...

May want to pull the dist cap and check for cracks, and see if the carbon button in the center is worn off, also check the rotor cap.
Forum: Ranger & B-Series 01-11-2015, 08:18 AM
Replies: 5
Views: 280
Posted By f5fordgirl
A ranger can be as reliable as anything else on...

A ranger can be as reliable as anything else on the road, or it can be a money pit just like your F-100. It all depends on who the owner was, how they drove it, and how well it was serviced, and...
Forum: Ranger & B-Series 01-01-2015, 11:35 AM
Replies: 3
Views: 298
Posted By f5fordgirl
So did you do a complete total rebuild, replacing...

So did you do a complete total rebuild, replacing all the disks and steels in the clutch packs. Along with replacing all the O rings and seals, and have everthing super clean? Or did you just replace...
Forum: Ranger & B-Series 12-25-2014, 04:52 PM
Replies: 3
Views: 198
Posted By f5fordgirl
Might be a pin hole in that hose, or the clamp...

Might be a pin hole in that hose, or the clamp could be loose, and only leaks with pressure in the system, as well as the water pump seal.
Forum: 1973 - 1979 F-100 & Larger F-Series Trucks 12-16-2014, 06:24 PM
Replies: 6
Views: 206
Posted By f5fordgirl
If you can use the orig trans, and leave it in...

If you can use the orig trans, and leave it in the orig place, drive shaft will be ok.
Forum: 4 Cylinder Engines 12-12-2014, 10:55 AM
Replies: 2
Views: 152
Posted By f5fordgirl
Have you checked the inertha switch, if its not...

Have you checked the inertha switch, if its not tripped, listen to see if the fuel pump kicks on when the switch is first turned on. Also check for fuel pressure, the fuel filter could also be ...
Forum: 1961 - 1966 F-100 & Larger F-Series Trucks 11-22-2014, 05:31 PM
Replies: 9
Views: 350
Posted By f5fordgirl
Look at the bellhousing pattern, if its the same...

Look at the bellhousing pattern, if its the same as a 460, its a 351m or 400. If its the same as a 302, then its a 351C.
Forum: Bronco II 11-10-2014, 06:49 PM
Replies: 2
Views: 295
Posted By f5fordgirl
Have you run a fuel pressure check?

Have you run a fuel pressure check?
Forum: Y-Block V8 (239, 272, 292, 312, 317, 341, 368) 11-02-2014, 08:10 PM
Replies: 4
Views: 372
Posted By f5fordgirl
How much was milled off the heads?

How much was milled off the heads?
Showing results 1 to 15 of 488

 
Forum Jump
 

Participate In The Forums

Create new posts and participate in discussions. It's free!

Sign Up »


All times are GMT -5. The time now is 06:00 PM.


Powered by vBulletin® Version 3.8.7 AC1
Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.
Advertising - Terms of Use - Privacy Statement - Jobs
This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. Ford® is a registered trademark of the Ford Motor Company.

vbulletin Admin Backup