Go Back   Ford Truck Enthusiasts Forums > Search Forums
Sign in using an external account
Register Forgot Password?


Showing results 1 to 15 of 500
Search took 0.11 seconds.
Search: Posts Made By: MeanGreen460
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 04-13-2014, 07:47 PM
Replies: 20
Views: 667
Posted By MeanGreen460
You need to pull transfer case to replace the...

You need to pull transfer case to replace the seal .
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 04-13-2014, 07:40 PM
Replies: 7
Views: 326
Posted By MeanGreen460
Is your truck a F150 or F250? Check your tire for...

Is your truck a F150 or F250? Check your tire for abnormal wear if wear pattern is abnormal cupped then tire could be making the noise .Also jack up wheel grab wheel assembly see if you got lots of...
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 04-13-2014, 07:25 PM
Replies: 10
Views: 340
Posted By MeanGreen460
I would have front end aligned the new springs...

I would have front end aligned the new springs will change camber and caster but toe in would be the most important factor to worry about .with radial tires I would set toe in 1/32 of a inch.
Forum: 1973 - 1979 F-100 & Larger F-Series Trucks 04-13-2014, 06:57 PM
Replies: 4
Views: 269
Posted By MeanGreen460
80-90 w gear lube in transfer case

80-90 w gear lube in transfer case
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 04-08-2014, 11:15 PM
Replies: 7
Views: 246
Posted By MeanGreen460
What I meant was no catalyst over 8600 GVW your...

What I meant was no catalyst over 8600 GVW your right they still had EGR and air pumps other emission crap.
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 04-08-2014, 11:03 PM
Replies: 12
Views: 639
Posted By MeanGreen460
I would pull front wheels pull hubs pull...

I would pull front wheels pull hubs pull spindles .Clean check spindle bearings clean repack front wheel bearings also
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 04-08-2014, 10:43 PM
Replies: 7
Views: 246
Posted By MeanGreen460
If over 8600 GVW your truck would have no...

If over 8600 GVW your truck would have no emissions but your showing 6100 GVW May be a Canadian thing .I know a lot of 1988 Canadian 351W and 460 engines were still 4 barrel carb while in the states...
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 04-08-2014, 10:35 PM
Replies: 2
Views: 169
Posted By MeanGreen460
Should be OK the 300 six and 302 were rated about...

Should be OK the 300 six and 302 were rated about the same FT LBS of torque
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 04-08-2014, 10:32 PM
Replies: 3
Views: 256
Posted By MeanGreen460
Never heard of a H O 302 engine only the 5.8 I...

Never heard of a H O 302 engine only the 5.8 I worked at a Ford Dealership from 1977 t0 1996. On those 302 EFI and fuel Injected engines Ford was running too cold of plug ASF 32 c we had a lot of...
Forum: 1973 - 1979 F-100 & Larger F-Series Trucks 04-08-2014, 10:20 PM
Replies: 12
Views: 465
Posted By MeanGreen460
Sounds like a worn weak syncro

Sounds like a worn weak syncro
Forum: 1973 - 1979 F-100 & Larger F-Series Trucks 04-08-2014, 10:12 PM
Replies: 3
Views: 333
Posted By MeanGreen460
Looks like you got a lot of spline showing .The...

Looks like you got a lot of spline showing .The question is how much of the splined shaft is in the other piece of driveshaft 3 inches? Is this the stock drive shaft setup? What you could do is shim...
Forum: 1973 - 1979 F-100 & Larger F-Series Trucks 04-08-2014, 10:02 PM
Replies: 6
Views: 342
Posted By MeanGreen460
There is 2 bolts on top of crossmember to frame...

There is 2 bolts on top of crossmember to frame you have to pull out .If you have all the bolts out you need to smack crossmember with a big hammer to get crossmember out .It will come out just use a...
Forum: 1973 - 1979 F-100 & Larger F-Series Trucks 04-08-2014, 09:54 PM
Replies: 26
Views: 854
Posted By MeanGreen460
You should be able to get 14 to 15 mpg with your...

You should be able to get 14 to 15 mpg with your truck I got 14.5 on the highway long 800 mile trip with a 78 Bronco with a 351 4 spd 3.50 rear gear ratio.Got 15 to 18 mpg with a 2wd F150 with 351...
Forum: 1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks 04-05-2014, 12:09 AM
Replies: 12
Views: 378
Posted By MeanGreen460
Wrong I have changed a lot of ring gears on stick...

Wrong I have changed a lot of ring gears on stick shift fly wheels The ring gear and flywheel are 2 separate parts .I heard of guys welding the ring gear on Auto flex plates never seen anyone do it...
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 04-05-2014, 12:03 AM
Replies: 12
Views: 354
Posted By MeanGreen460
White Smoke is water and antifreeze ;possibly...

White Smoke is water and antifreeze ;possibly leaking head gasket cracked head .Meaning your getting water in combustion chamber from cooling system .
Showing results 1 to 15 of 500

 
Forum Jump
 

Participate In The Forums

Create new posts and participate in discussions. It's free!

Sign Up »





All times are GMT -5. The time now is 09:39 PM.


Powered by vBulletin® Version 3.8.7 AC1
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Advertising - Terms of Use - Privacy Statement - Jobs
This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. Ford® is a registered trademark of the Ford Motor Company.

vbulletin Admin Backup