Go Back   Ford Truck Enthusiasts Forums > Search Forums
Sign in using an external account
Register Forgot Password?


Showing results 1 to 15 of 18
Search took 0.19 seconds.
Search: Posts Made By: bluecobra
Forum: 1997 - 2003 F150 07-01-2014, 04:50 PM
Replies: 6
Views: 323
Posted By bluecobra
Got bearings & seal for the 9.75. Pulled the old...

Got bearings & seal for the 9.75. Pulled the old ones and discovered the the 9.75
bearings were too big. It took the 8.8 bearings instead. Go figure!
Forum: 1997 - 2003 F150 06-25-2014, 07:00 PM
Replies: 6
Views: 323
Posted By bluecobra
Thanks Bluegrass, I did get under and its a...

Thanks Bluegrass,

I did get under and its a 9.75 RG.
Forum: 1997 - 2003 F150 06-25-2014, 11:57 AM
Replies: 6
Views: 323
Posted By bluecobra
Ring Gear Size

I have an 2001 F-150-5.4-4wd-H-9 diff.


Looking on RA to buy rear axle bearings. How can I tell if the ring gear is 8.8 or 9.75. I have seen posts that said if the diff cover has 10 nuts its 8.8...
Forum: 1997 - 2003 F150 05-22-2013, 07:44 PM
Replies: 6
Views: 1,007
Posted By bluecobra
I agree with Mr BIG

I agree with Mr BIG
Forum: 1997 - 2003 F150 03-27-2013, 07:52 PM
Replies: 2
Views: 664
Posted By bluecobra
COP question

2001 with 5.4 160K.
This past weekend I started having a missfire. A quick look under the hood and spotted a heater hose leaking onto the #1. Repaired the hose, removed coils 1,2,3 and blew out all...
Forum: 1997 - 2003 F150 11-17-2012, 09:16 AM
Replies: 2
Views: 362
Posted By bluecobra
there's a post by Plug-n-Jug on 11-12 that...

there's a post by Plug-n-Jug on 11-12 that details the core replacement.
Forum: 1997 - 2003 F150 11-14-2012, 12:07 PM
Replies: 3
Views: 1,136
Posted By bluecobra
You should find a schematic of the vac lines on...

You should find a schematic of the vac lines on the sheild on top of the radiator. I can see the PVC on the valve cover.
Forum: 1997 - 2003 F150 09-01-2012, 05:08 PM
Replies: 2
Views: 359
Posted By bluecobra
Smile Check out this site for some great how to troubleshooting.

Stumbled on this site looking for help with some elusive engine problems. Hope this is useful.

HOW TO TEST IGNITION CONTROL MODULES and MASS AIR FLOW SENSORS and MORE. Easy, simple and fast...
Forum: 1997 - 2003 F150 08-28-2012, 01:48 PM
Replies: 2
Views: 320
Posted By bluecobra
I've checked the pvc line and gone over every...

I've checked the pvc line and gone over every line I could find. Replaced some. What is the VM Valve? Also, one of the lines I replaced was the one going from the brake booster to the TB. ...
Forum: 1997 - 2003 F150 08-28-2012, 11:47 AM
Replies: 2
Views: 320
Posted By bluecobra
Engine wants to surge.

2001 F150 5.4 4x4 148K

I recently replaced the intake manifold on this truck and when the engine revs it wants to continue at high RPMs for about 10 seconds after letting off the throttle. When...
Forum: 1997 - 2003 F150 08-13-2012, 08:53 PM
Replies: 3
Views: 594
Posted By bluecobra
Went to O'Reilies and got the codes: PO171...

Went to O'Reilies and got the codes:

PO171 System too lean (bank 1)

PO113 Intake Air Temp. Sensor 1, Circuit High Input

PO174 System too lean (bank 2)

PO301 Cylinder 1 misfire...
Forum: 1997 - 2003 F150 08-13-2012, 03:25 PM
Replies: 3
Views: 594
Posted By bluecobra
Suggestions on possible vacuum leak.

I just replaced the intake manifold (had a coolant leak at the crossover that was shorting the coils) on my 2001 f-150, 5.4. It runs great until it warms up and then it starts to miss. I get codes...
Forum: 1997 - 2003 F150 07-29-2012, 03:18 PM
Replies: 5
Views: 2,437
Posted By bluecobra
Thanks Steve. I can see where it bolts up into...

Thanks Steve. I can see where it bolts up into the intake. There's no way to get at the bolt head without taking the intake and everything else off. It looks like the crossover was attached to the...
Forum: 1997 - 2003 F150 07-29-2012, 03:08 PM
Replies: 25
Views: 6,276
Posted By bluecobra
Are you sure its not the transmission sticking?...

Are you sure its not the transmission sticking? When's the last time the fluid was changed? The 4R70W will stick and cause a problem. Ford has an additive that may help, but I'd start with a fluid...
Forum: 1997 - 2003 F150 07-29-2012, 01:11 PM
Replies: 5
Views: 2,437
Posted By bluecobra
coolant leak/fix

I have a 2001 F-150 5.4 engine. There is a coolant leak where the coolant leaves the head. Looks like a new gasket is in order. The part that needs to come off crosses over to the driver's side and...
Showing results 1 to 15 of 18

 
Forum Jump
 

Participate In The Forums

Create new posts and participate in discussions. It's free!

Sign Up »





All times are GMT -5. The time now is 09:41 PM.


Powered by vBulletin® Version 3.8.7 AC1
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Advertising - Terms of Use - Privacy Statement - Jobs
This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. Ford® is a registered trademark of the Ford Motor Company.

vbulletin Admin Backup