140v question
 

Hello everyone I was just wondering if anyone that has a 94.5 to 97 powerstroke has done the 140v thing to there idm and the ipc and eot thing here in Washington, and how well it works.Also dose it affect any thing if you later put a chip in.Dose it just stack it or cancel the mods out

Its stacks. Just do it, You'll love it.

Crash, out of curiosity, are you looking for a new transmission?

well at one time i was looking for a trans. I found a 5 speed and put it in.So on the mods and a chip it will stack?SO if i add 30hp with mods and then later put in 70 HP chip it will give me over all 100hp then . cool.

Whatever you do, stay away from Banks,Edge,Superchips. They are not chips, they are programmers. Unless you are plugging into the PCM.

Just curious about the Trans, there is somebody from your area looking into a BTS.

So no programmers. So I think that would only leave a few chips out there that plug in line like that right.So why not any of those.

I dont no about the tranny thing. no one i no of around here.

Dp Tunes. You will get more power with different settings and much better service.

Some people are running the new Swamps Hi-Frequency and output mods in our IDM's...... wonder who it could be?.....:confused:8D

Cowboy Steve

Steve, do you have a schematic on that new IDM?

I wish. Dave at Swamps wouldn't release that to the public. So far, their the only ones doing the mod. It works nice but is kinda spendy

Cowboy Steve