B&W turnover installed
 

I realize there are probably hundred of pix like this on this forum but snapped these today after mine got installed. Companion slider hitch goes in tomorrow. That thing is a beast!

https://cimg0.ibsrv.net/gimg/www.for...abbf004316.jpg


https://cimg1.ibsrv.net/gimg/www.for...d1c17e9158.jpg


https://cimg2.ibsrv.net/gimg/www.for...c74218f63a.jpg

Everything looks as it should.

One of the first things I did when I got my truck was to paint all that hardware. You might do that before it gets dirty.

Yes, yes it is. It is NOT a one person job to install.

Looks great except that notch in the bed would bug the Crap out of me..

I thought it would too on mine but it doesn't. :)

Sent from my Telegraph using IB AutoGroup

Its the cheap way to do it, I have the same hitch but no notch. I suppose they didn't want to raise the bed...:'(

I specifically asked them not to raise the bed. I don't care about a notch in the bed flange. Just a truck. :-jammin

Some trucks it fits without notching, there need to be notched. I tried without notching but finally said screw it and cut it out.

Sent from my Telegraph using IB AutoGroup

you guys and your fancy notches ....

i'da just beat it with a hammer :)

I get that, My hitch was in when I bought the truck so I didn't have to tell them to do anything, I am very anal about that kind of stuff though. When I did my 6.0 cooler mod I didn't just use splices on the lines like everyone else does I got the factory ford lines and transitioned them instead.. I do like Meborders suggestion of just beating it with a hammer..:)