Parting 96 F150 sc 5.0, at Grey interior
Hi all,
UP date on engine. I got it to run feeding it fuel. It sounds good and oil pressure came right up. I was told it runs good when I got it, and it seems to. I also pulled the rear gas tank out. It was just put in, like brand new. See pics in CL add. Fuel pump was bad. Thanks, Joe Just pulled a 96 f150 2wd, sc, has a non running(right now) 5.0 and auto trans. It has a fuel delivery problem that I will look at before parting out. 139 k miles and looks very clean under the hood and interior. Transmission fluid very clean. Another truck eaten by rust. Usual rusty Western New York body, so only a decent drivers door as far as sheet metal goes. But many other good pieces. Manual windows, has a/c with a reman compressor dated 2011. Clutch spins free. Write with needs. Hood, seat and tail gate are gone. See photos here, http://chautauqua.craigslist.org/pts/4612975285.html http://chautauqua.craigslist.org/pts/4614279369.html Joe Walters Kennedy, NY 716 969-8702 cell |
Theres a metal pipe that attaches to the alternator,, thats a mid pipe for the coolant hose from the heater box, leading to the water pump...you have one in good shape?
|
Motörhead.
I will check and get back to you. Thanks, Joe W |
You've got mail, Let me know.
|
Let me know if you're willing to sell the cluster and bezel.
|
Originally Posted by rock15t
(Post 14590569)
Let me know if you're willing to sell the cluster and bezel.
Thanks, joe |
Originally Posted by The other Joe
(Post 14590686)
Hi, yes the bezel and cluster. How's $90. Plus shipping.
Thanks, joe |
Originally Posted by rock15t
(Post 14592584)
Can you get a price on shipping to 47711
I sent you a pm. Thanks, joe |
I didn't get the pm
|
Rock, you may have to enable private messages. See instructions below.
But for now. Shipping should be 25-30 dollars. I can't get a exact price until parts are boxed, weighed, etc. They are still in the truck. If it's more than 30, I will cover it. If it's less, I give you back the change. Thanks, joe A: Contact through private messaging in preferred, and posting your e-mail address or phone number in the open forums is generally discouraged. To enable private messages, you must first have 25 or more posts, then click the "user cp" icon at the left end of the blue bar just above the forum list. Click the "edit options" category, and make sure the options to receive messages from users is selected. |
I'm looking for the drivers side A pillar trim, would you happen to have one?
|
How much for dash bezel and gray dash pad shipped to 32833?Paypal?Reply by PM please.
|
Originally Posted by coreyallan01
(Post 14632852)
I'm looking for the drivers side A pillar trim, would you happen to have one?
I am pretty sure it's good. I will check to make sure and write back later. Thanks, Joe |
Hi all,
Just to update. I still have the nice running 5.0 engine with od trans available cheap. I will now also sell any engine accessories and electronic parts. I wanted to sell everything as a package. But didn't get any interest. So, now I am willing to part it all out. Please write with needs. Thanks, Joe W. |
Coreyallen and frogman2,
You 2 have mail. Thanks, Joe |
You have the instrument cluster from the 96? Does it have a tach?
|
Originally Posted by mrrish79
(Post 14660410)
You have the instrument cluster from the 96? Does it have a tach?
I have one from a 94, but no tach. Thanks, Joe W. |
Do you have the dash pad and pass side pillar trim?
|
The dash pad has a small hole in it.
I do have the trim piece. I think you are asking about the A pillar piece that also goes over the door also. Pm me or email me at oldsrip@yahoo.com if you want pics or have any more questions? Thanks, joe |
Do you have a serpentine belt setup on the engine? If so, I'm interested.
|
All times are GMT -5. The time now is 05:13 PM. |
© 2024 MH Sub I, LLC dba Internet Brands