Ford Truck Enthusiasts Forums
Page 2 of 2
1
2
Show 40 post(s) from this thread on one page

Ford Truck Enthusiasts Forums (https://www.ford-trucks.com/forums/index.php)
-   1994.5 - 1997 7.3L Power Stroke Diesel (https://www.ford-trucks.com/forums/forum170/)
-   -   Favorite Method To Get Spindle Out Of Knuckle D60 (https://www.ford-trucks.com/forums/1327747-favorite-method-to-get-spindle-out-of-knuckle-d60.html)

glovemeister 07-30-2014 10:21 PM
Originally Posted by Diesel_Brad (Post 14545962)
Ever since I have found the slide hammer with adapter, It takes less than 15 hit ANYTIME . The block of wood, magazine, chisels, etc have wasted HOURS of my time and I will NEVER use them again.

Last week I took an 86 apart that was NEVER apart and it was a plow truck its whole life(200k) and IIRC it took 8-10 hits per side to have them on the floor
I tried it and I was over 100-150 strikes with the slide hammer adapter. I used a 10 lb slide hammer.

Diesel_Brad 07-31-2014 04:31 AM
Originally Posted by glovemeister (Post 14546484)
I tried it and I was over 100-150 strikes with the slide hammer adapter. I used a 10 lb slide hammer.
You better put down the PURSE and put on some M A N

fordman67 07-31-2014 07:59 PM
I bought the slide hammer attachment..I haven't gotten to use it yet.after the last time I had mine apart I was inspired to get the right tool.I sure hope it works as well as I hope.

strokin'_tatsch 07-31-2014 09:04 PM
Originally Posted by fordman67 (Post 14548660)
I bought the slide hammer attachment..I haven't gotten to use it yet.after the last time I had mine apart I was inspired to get the right tool.I sure hope it works as well as I hope.
It works every bit as good as you hope it does. Lol. 3-5 minutes vs 6-7 hours for me.

fordman67 07-31-2014 09:20 PM
And I didn't do my dust shields any good with the chisel.


All times are GMT -5. The time now is 09:43 PM.
Page 2 of 2
1
2
Show 40 post(s) from this thread on one page


© 2024 MH Sub I, LLC dba Internet Brands