Built 1978 Ford F250 4x4 w/dana 60 axles
 

This truck has less than 3000 mile on a frame up. Stripped down to bare frame and sandblasted. New brake lines, fuel lines, trans cooler lines. Motor is a 460 bored out .30 has a mild cam, with a 750 edelbrock carb. Trans was just rebuilt also. Has a stage 2 shift kit with lots of new parts. Transfer case is a NP205 with no known issues. Rear driveshaft was custom made. Front axle is the Dana 60 snowfighter axle with a dana 60 rear also. Has 410 gears. Has a flat bed with a scissor dump hoist with removable sides. Have a stock bed for it, very minimal rust but has a couple dents to fix on driverside. I did all this work 3 years ago, the bad is i used cheap paint and it sun faded extremely bad. It has two big dents that need repaired. It has an 8' meyer snowplow on it (plow could use some tlc) with a dmi rear bumper.