Looking for a rust free hood and 65,66 side molding LB

Aaron, As I recall it is better then what you posted...post your email and we can talk more...W. Seattle is good for me location wise..

Bronco...you can email or PM me...or others after you hit 25 posts on here...or you can post your email addy and we can go from there.

Fseries, I have very little racetrack trim...which pieces are you in need of ??

rdegroff...I have lots of knobs...which switchers are you in need of ? I believe I have a t/signal lever too. No slider, but I do have a dash bezel too...are you seeking one with or without the holes for the optional alt/oil pressure gauges ??

Dave145, no slider...I sold the dentside gate I had, but I do have all of the trim for it.

gfpilot, I do have an EXCELLENT hood..side trim...are you seeking a full set or just bed pieces ? I do have a couple of NOS pieces as well...

jasonm2131...I have a dashpad, some vinyl type upper body moldings, tailgate trim, and a few of the ribbed lower body moldings.



- cs65

well i have a regular cab long box and the guy before me deleted it and i bought it as a project i need all of it if u got it lol

I don't know how to PM on this forum but yes I am looking for a whole set mine were discarded by pervious owner during repaint. The hood I have is just not good enough for this slick. my email is hubpilot at me dot com

NEED TO FIND A BIG BACK WINDOW FOR A 61' UNIBODY ANYBODY CAN POINT ME IN THE RIGHT DIRECTION PLEASE

whats a racetrack, sorry i just dont know??

whats a racetrack?

racetrack trim was used on the dentsides..77-79 as I recall...its also used on vans of the same era as well as the 80s...

gf pilot...The moldings I would need to go through my collection and see what all I have...If you are looking for driver quality let me know...they are all cloudy/foggy except the NOS parts..
On the hood...It would need to be shipped by truck due to its size...and crated.

FseriesMike...does your truck have a bedside toolbox ??

aaronsbicyclerepair, whats your email address ?? Post here and I can show you what I have...



- cs65

An update...

The 78-9 Grille shell assy has been sold...I have a pair of headlight doors though still....

I also now have an 80-86 Flareside tailgate in excellent condition, original paint.



- cs65

looking for driver quality - drivers side door and drivers side long bed molding -

have anything like that around?

Do younhappen to have a set of 61-64 scuff plates? Thanks Bobby
My email address is Bobby_saphire95gt@yahoo.com

how much for the 73-79 dash pad to 28532??? email is hillbilee@hotmail.com

hood
 

Hi can you call me abouy the hood 1-773-965-5483

I'm in need of a tie rod tube/sleeve for my 64, looked at eBay, LMC & DC as well as other sites- no one has a new one. I can get tie rod ends and I know I'll need to replace them, but a new or really straight used one is needed to replace my bent one. Can ya help or point me in a known direction?
Thanks

I'm in need of a tie rod tube/sleeve for my 64 F100, looked at eBay numerous times, LMC & DC as well as other sites- no one has a new one. I can get tie rod ends and I know I'll need to replace them, but I need a tie rod first. A new or really straight used one is needed to replace my bent one. Can ya help or point me in a known direction?
Thanks