79 f250 super cab 4x4
 

So i picked up this super cab a few months ago and have been working on it little by little. It is a lariat model so it came with all the bells and whistles like tilt column, intermittent wipers, lighted vanity mirror, and so on..I picked it up for $900 and about 5 hours of driving north to get it. it had a rebuilt 400 engine and c6 trans, np205 tcase with a dana 44 front axle and 60 rear.
heres when i first brought it home.
Attachment 230180
Attachment 230181
Attachment 230182
first thing i did was remove the camper
Attachment 230183

I then swapped in a front dana 60 with crossover steering and installed a 6" skyjacker lift and 37" tires. also put on my bumper with warn 12k winch.
Attachment 230184

i cleaned up the engine bay a bit and installed dual optima red tops, new super cooler radiator and a few other things.
Attachment 230185
Attachment 230186
Attachment 230187
Attachment 230188

Now im at the point where im swapping in a np435 manual trans. i had the trans rebuilt by a friend and i resealed the transfer case.
Attachment 230196

since im already going to have the rear drive shaft redone with 1350 yokes im going to swap in a 14 bolt with a detroit locker and disc brakes.
Attachment 230197

I just started tearing it down today and here is how it sits.
Attachment 230198
Attachment 230199

they day you brought it home, was worth $3000 up here all day long.

Same here. This is the kinda find you only hear about and piss and moan cus you wish you found it haha.

What type of crossover setup did you use? I'd like to see some pics if you have some.
Thanks

Cursing you...nice truck!

Are you rich or something?? haha

i got the steering arm off my buddies chevy dana 60 for free and i ordered the crossover tube and used chevy tie rod ends. i already had the drop pitman arm i just had to rotate it 90 degrees.
Attachment 230200<embed id="ZeroClipboardMovie_4" src="http://pic.pbsrc.com/flash/ZeroClipboardFV2.swf" loop="false" menu="false" quality="best" bgcolor="#ffffff" name="ZeroClipboardMovie_4" allowscriptaccess="always" allowfullscreen="false" type="application/x-shockwave-flash" pluginspage="http://www.macromedia.com/go/getflashplayer" flashvars="id=4&text=%255BIMG%255Dhttp%253A//i32.photobucket.com/albums/d49/boggin79ford/Big%252520green/DSC00116.jpg%255B/IMG%255D" wmode="transparent" align="middle" height="100%" width="100%">

haha i wish.... im broke i have been saving parts for a while now..

I wish I could find a deal like that....

Wow, very nice truck and a steal for $900. There is one very similar to that for sale locally for $5000. And he will probably get that for it.

Thanks. I was hoping you had a bought kit. I like the looks of the crossover and I'm sure it drives better than the push/pull. I'm in the middle of the D60 swap and it looks like I'm going to need a drop pitman arm and another drang link possibly. So I'm trying to decide if I should just go the crossover route.

That is a very good looking truck. Where did you find it? I'm about 5 hours North of you. Just curious.

I bought the cross over kit from Sky Manufacturing