Ref : http://www.ford-trucks.com/forums/11...with-pics.html

I had a friend get me what are supposedly the Ford factory lines.. part #'s 5c3z-7r081--ca, and 5c3z-7c410-aa. Somehow, they don't look right for this conversion. Do these #'s match the part #'s you bought? Did you need to buy anything else from Ford like plastic disconnect pieces etc? I got the compression fitting you recommended and the barbed fittings.

http://www.ford-trucks.com/forums/11...with-pics.html

Regarding above...do you have the part # for the Ford 6.0 lines, and a part # for that compression fitting you bought on e bay. I like your set up !

Thanks for the reply. I searched and found several moon roof leaks that suggested the drain lines but no one I found had any real solutions on how to clear them and where they are located as I understand that come out at bottom of vehicle somewhere. But where? Most were other Fords but not the F 250 so results and solutions might be different. If you have any suggestions, I would appreciate it very much.

do you still have the superduty hubs and if so where are you located at in mn. Dennis