I sent you an e-mail today but incase you didn't get it I live in Mcloud outside of Shawnee my motor is an 85 302 that came out of a truck its not a roller motor wish it was but its not. We put the motor in a couple of weeks ago and the oil pan was wrong. Got a new one and put it back in this last weekend. Then according to all the guys on the site here I have a dist for a fuel injection set up and I'm using a carb. So I'm told I need a duraspark II dist., coil, and module? I have no plugs under my hood for this just some wires wraped in electrical tape comming from behind the drivers side valve cover.Autozone to the best of my knowledge carries this dist. but not sure about the module thing. Thought about going to pull a part to see if I could find one but would rather have a new one. I'm sure to have alot of other questions but like to wait until I'm at that point.

Thanks, the truck got put onhold so I could finish my shop, the motor is a 89 roller 302 out of a mustang, its been bored so I think it ended up being like a 306. I just started working on it again yesterday, had to cut the motor mounts back out and move the front motor over about 3/4". I didnt notice it untill I had put the front clip back on and it didnt look right. You said your from oklahoma, where at. I would be more than willing to help u with wiring your motor, just need sme details where your at with it.
Leon