Thanks for the heads up Allan

Mervy49
You should check out the Canadian Rodders Forum
Allan

In regards to trades for glovebox door and ash tray .
What are you looking for ?

Allan allanbrtrains@live.com or allanbr@nait.ca

Hey Earl, if that Ford F1 Transmission is in good shape I would be interested in hearing how much you want for it. logisticsjoe@aol.com

Thanks,
-Joe

I tried replying to the private message you sent, but I got an error message saying you can't or won't receive pm's.

Thanks Earl, I appreciate you remembering. I did find one on ebay a while back, but it has two big 1/2" holes, one on each end, I'm going to have to try welding up. The biggest problem with that is, I'm not a very good welder. lol. If you happen to come across a good one, I'd be for sure interested in at least knowing about it.
Thanks,
Wayne

Check out the 2011 FTE Championships!

I guess I should have replaced the cab mounts but I chose to just cut them off. I shaped a piece of 1/8 plate to fill that irregular shaped indent in the new floor boards and then welded the remaining up right cab mount o that. The new floor boards turned out great I think. They sure were expensive though.

When you put the new floor pans in, did you have to deal with the front cab mounts? was it a pain to get it done, and are you happy with the end results of the floor?
I am thinkin about gettin new ones for mine. they are not horrible but there are a few holes(very small ones) here and there. I have done some floor pans but they were on a 78 Bronco. just curious! Thanks! Jeff

Hi everone. I haven't been in here for a while, Been working on the 49 and camping with my wife and doing all the fun summer things. Will be back on soon adding to the chatter.......

Welcome to the BC Chapter.

If you want to join in some chat.
BC's June Come On In For A Chat, All Welcome - Page 11 - Ford Truck Enthusiasts Forums

Your intoduction to the chapter.
http://www.ford-trucks.com/forums/96...ml#post8978155