Hello, wondering if you could help a fella out, I did a zf5 swap on my 97 last spring without touching the ECM. I simply put the selector under the truck in neutral and it starts fine. I spliced in the reverse light pigtail to get backup lights. Problem is my cruise doesn't work. It is my understanding that it should work. I did the same swap on my 1994 idit and cruise worked after, thought that was vacuum not electric. I was thinking maybe the cruise wouldn't work seeing as the ECM thinks the truck is in neutral, but other threads I've read indicate it should function. I'm thinking about tearing into the steering column to see if I left anything unhooked but I just wanna make sure it should work first. Thanks

Hi I did a 5 speed swap as well and I am using a 95 PCM with a manual harness for the trannyand I cant get it to start. It will turn over but no fire or try to fire and no WTS light. I switched all the pins on the tranny side of the harness and checked all fuses and nothing. Any ideas?

Hey with that jumper wire in the transmission harness where do I move it to.

i just did the 5-speed swap in my 96 and it all worked out good. but i didnt have a pcm to swap over and i wanted to know if you knew what wires to jump out. the truck runs and drives but has no nuts i have my ts6 all the way up it then it drives like a stock 5-speed. if you could email me if you know anything that would help it would be great thanks. choenshell07@gmail.com

Thanks for the rep amigo.

Thanks for the rep!

I hit you in a minute for that valve find. Take care and keep up the none ego post, your managing that way better than some.

Thanks for the rep from Jose

Hey redman. I live in Austin and I am about to start the auto to manual swap and had a few ?s for you. If you have time shoot me an email ihasfip@yahoo.com and I will pick your brain.

Thanks,

D

haven't seen ya around the Texas chapter in a while. hope we didn't run ya out LOL