Hi, I could use parts off the engine. Top of the list is the water neck thermostat housing if it in good shape. Other nice bits would be the throttle linkage (as far back as you've got it), starter mounting bracket (that goes to the oil pan). Oil pan bracket/clamp for the crankcase vent tube, wiring loom and tubing brackets, water temp sensor line, oil pressure sensor line, etc, etc all the accessory stuff like that. Please email me at jwhowl@verizon.net. Thanks, John

ok. thanks for the info.

bought the one here locally as he was in the mood to sell . got it for 50 bucks . thanx . don't know what the going rate is for them , but ya got a couple of guys on here that like the biguns in ohio so you might hear from one of them .

Welcome to the Indiana chapter!...check out your welcome thread here: http://www.ford-trucks.com/forums/11...l#post10926186

Let me know if you have any questions.

Joe.

what 's the price on the critter . i will however give you a clue if your building a 53 -56 . the f600 box is a much quicker ratio than 1/2 through f400 boxes . got one to go look at here sunday and the guy is on again off again about pasrting the rust bucket out so ...............