I'm interested in your lower tailgate trim. I think you have it listed at $15. Thanks!

Hi Steve,
Steve Bricks pointed me in your direction. I have been rebuilding a 71 F250 Camper special for my daughter for a couple years. The tow truck let it roll off the bed while unloading the truck at the upholstery shop. Took out the Aux fuel tank (which I use for primary, removed the in cab tank) and took out the drive shaft from the carrier bearing to the rear axle. I already replace all unjoints and carrier bearing. Trying to locate a good drive shaft.

Any ideas on where I can look besides souring wrecking yards?

Thanks,
Chris

Hey bud i was wondering if you were still fabbing and selling cummins mounts. Im getting ready to start my cummins swap on my lowboy. Shoot me an email at dakota_brenner@yahoo.com. Thanks!

Stock leafs by the way

Well I also have a bead on some stock super duty springs for 70 bucks. Do you know if these at least level my truck?

Hi I'm working on my 78 f250. The front springs are shot and I am looking into a lift. I found four inch soft ride lift springs for a 3/4 ton chevy. Do you know if these will work? I do believe they are longer and should be 2.5 or 3 inches wide. I hope you can get back to me. Thanks if you want e-mail me sa-balla@hotmail.com thanks

Do you still have any bumper brackets (front) for a highboy

chasetruck754, my name is ed (blue 76) i am searching for extendafender flares for my 76 150 and it seems as though all roads are leading me back to you, would love to hear from you thanks ed you can email me at edrobbearts@gmail.com

chasetruck754, my name is ed , would you mind emailing me i have a question that you may have the answer to about my 76 f150 thanks ed .... edrobbearts@gmail.com

sure ill take a look at them.. I'll do a little research as well to see if I can use them or not