Ford Truck Enthusiasts Forums - View Profile: CTom

CTom is starting off with a positive reputation.

CTom CTom is offline

Junior User

Visitor Messages

Showing Visitor Messages 1 to 3 of 3
  1. Bill W
    09-12-2010 11:34 PM - permalink
    Bill W
    HEy Tom, I am having 3 sets of brackets made this week. i found a business that has a plasma table and i found 1/4 inch cold rolled steel to make them from... would you be intrested in a pair of them? my cost will be around 100 bucks a pair... maybe a little less. I do plan to write up a how to artical about it.
  2. CTom
    08-27-2010 08:04 PM - permalink
    Thanks for that info.........Good luck with the project, This may make a good "how to" post.
  3. Bill W
    08-26-2010 09:09 PM - permalink
    Bill W
    Hey Tom, I just got in from working on them. So far i have rotors from a mid 70's chevy 4x4 3/4 ton truck... had the hubs machined to fit and i am working on finding wheel studs long enough to work with the rotors I think that will be the hardest part of the whole deal... making a bracket to fit a GM caliper will be easy to do.
    I will let you know how i progress on the swap.

About Me

  • About CTom
    Rhode Island and PP
    2 Letter State/Province (use "--" for outside USA/
    Country of Residence
    Current Mileage
    Rather not say
    Miles per year
    Rather not say
  • Signature
    New England Hot Rods


Total Posts
Visitor Messages
General Information
  • Last Activity: 02-18-2016 11:42 AM
  • Join Date: 01-05-2007
  • Referrals: 0


Showing Friends 1 to 3 of 3

All times are GMT -5. The time now is 01:04 PM.

This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. FordŽ is a registered trademark of the Ford Motor Company.