Ford Truck Enthusiasts Forums - View Profile: murph1



murph1 is starting off with a positive reputation.

murph1 murph1 is offline

Senior User

Visitor Messages

Showing Visitor Messages 1 to 1 of 1
  1. DanoFF50
    11-30-2009 03:23 PM - permalink
    DanoFF50
    Hi Craig,

    I'll ship out a sample can this week. You could spray it below 35 degrees without any problems. In the aerosol can it will just come out a bit heavier, but it will still spray. For your truck, I would recommend purchasing a gallon and use an undercoating gun or airless paint sprayer to apply. It leaves a wet, non-drying film, so you will get an initial dusting. You will not get any type of build-up, though, since Fluid Film never gets gummy or tacky. It remains very slick.

    We do not sell direct, so you would want to purchase through a distributor. You can find your closest dealer by visiting our website at Fluid FilmŽ | Corrosion Preventative, Lubricant and Rust Inhibitor and clicking on purchase.

    Best regards,

    Dan

About Me

  • About murph1
    Location
    southeast mi
    2 Letter State/Province (use "--" for outside USA/
    mi
    Country of Residence
    US
    Make
    Ford
    Model
    F-150
    Year
    2010
    Current Mileage
    50,000 - 74,999
    Miles per year
    5,000 - 9,999

Statistics

Total Posts
Visitor Messages
General Information
  • Last Activity: 11-07-2012 09:39 PM
  • Join Date: 08-21-2005
  • Referrals: 0

All times are GMT -5. The time now is 11:10 PM.


This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. FordŽ is a registered trademark of the Ford Motor Company.