I have been looking at your bed roll lights on a thread here as well as ebay. I am assuming the bulbs are sealed and can be changed out when and if they were to burn out or go bad? Do your lights come with mounting instructions, basically what wire goes to each running, brake and turn?
Do you sell off of ebay to save a bit of money?
The transmission is supposed to be out of a 89 CHP Mustang. The sensor I need will have a gear on the side of the cylinder that slips into the transmission, The one I have has a square drive (about 1/8") on the tip of the sensor. Nothing in the transmission to mate to this, just a plastic gear off to one side of the opening. Any idea what sensor I need?
This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. FordŽ is a registered trademark of the Ford Motor Company.