I have 1965 Ford F100, that I just bought and would like some help decoding the warranty tag.

warranty number
F10DR582825

w.b.
115

Color
wm

Model
F100

Body
B81

Trans
A

Axle
08

Last line is as follows
5000 172 4000 62


Thanks
jd

Hey Don, I called around to a few of the places you suggested for the RH upper vent frame pivot for a 66 F100, however no one seems to have one. You mentioned you might have one, do you happen to still have this avaiable?

Hello Camperspecial65, I'm desperately in need of a wiring diagram of a 65 F10 Ford truck. After reading one of your notes I came across the message indicating availability. If this is correct, I would appreciate an email. I'm in the middle of a 65 that's been retrofitted with an FE 352. The previous owner installed a Chrysler radiator and ignition switch which has me pulling my hair.

Thanks in advance for listening and any help that may be forthcoming!

A Sage once stated, doing the same thing over and over while expecting a different result was insanity!

Hi Don, thought I'd try you here. The trucks on hold until I find the cage nuts. I sent an email with pics when I returned from vacation, but haven't heard from you. Let me know how I can help. Thanks, Devin

Sorry I did not see your message. My truck is 2WD. Has a three speed now, but is going to have a 4 speed, since I find the three much too high in the low gears, and the rear end is 3.5. It needs a T-18 and a 3.0 rear. JB

CS65: Hi. I need a transmission tunnel cover that will fit a 66 F100.
thanks, j66b

Hi, looking for a 1965 f100 heater switch. Have economy heater with bezel that says "Pull for Heat: I believe it is part # C5UZ18578A. Would you have one for sale? e-mail is georgann@mchsi.com. Thank you.

Hi, This is 62 Squire and I posted the request for the cage nuts attached to the radiator support of our '62 f100. These are not J or U type, but snap into a rectangular hole approximately .5"x.75", and have a 5/16-24 thread, though 18s will work. the stone guard/valance and grill are attached to the radiator support with these.We need all five. My email is devin@bigbangip.com. Thanks

Hello again, in regards to the plastic horn ring. Here's my email: onavarro@comcast.net

Thanks, Ozzie

I am looking for the spacer that goes between the carburetor and manifold in a 1965 f250 352 2barrel. thanks.