jeffbradbury7@msn.com for a 1991 7.3 idi return line kit

how do you take orders . web site,phone ,email. Have 87 6.9 needs injector seals replaced. hard to start after sitting more than a day. almostmagicranch@aol.com

Hi Russ. do you still have the ATS 093 seal kits? Thanks. cr8zyd8ys@gmail.com

hey, I'm going to rebuild a 7.3 in the near future. I've been reading about your cam and would like to give one a try.

dear sir could you please send me the info on your fuel line kit for a 93 n/a 7.3 . cost shipping and a address, and type of payment. rusty escott . rustyescott@yahoo.com

I was referred to you by BASHBY as per my post at
http://www.ford-trucks.com/forums/12...l#post12663834

PLease read my post and let me know your thoughts - I would love to hear what you think and if the kit is the right way to go based on your knowledge - i woudl like to do that ASAP please - let me know how soon and what you need from me.

Seems like everyone thinks you are a rockstar here - definitely would love to have your opinion and support your efforts.

Thanks in advance for your support
-Steve
ssanchezsr@verizon.net

hello i was referred to you in a thread i started.
http://www.ford-trucks.com/forums/11...l#post12200890

do you still sell these kits?

thanks
Larry
larry.s.mcdowell@gmail.com

Hey Russ I am wanting to get a turbo reseal kit for my ats 093 my email is tomtomwashere@gmail.com Thanks.

Hey Russ, got the return line kit today. Thanks for sending it out. My other parts should be here shortly. Thanks for the help.

Hey Russ,

I can not for the life of me get this return line kit to stop leaking. Do you have any suggestions? I am going to need some more o-rings, and fuel hose. I already used the two extra o-rings I got with your kit to replace two that were leaking, which worked. I think I have two more to replace and hoses leaking in a few spots!. I can't figure it out. I did my 93 a few years ago with a kit from Kragen and it hasn't leaked a drop. Let me know, I can probably get the fuel line around here, but IDK where to get the o-rings.

Thanks,

Jim