Ford Truck Enthusiasts Forums - View Profile: Just Strokin

Just Strokin is a splendid one to beholdJust Strokin is a splendid one to beholdJust Strokin is a splendid one to beholdJust Strokin is a splendid one to beholdJust Strokin is a splendid one to beholdJust Strokin is a splendid one to behold

Just Strokin Just Strokin is online now

Posting Guru

Visitor Messages

Showing Visitor Messages 1 to 9 of 9
  1. Just Strokin
    09-13-2016 12:25 PM - permalink
    Just Strokin
    watch the video on how to install basically start by installing only the v81 calibrations files and then install a full version of IDS
  2. gump2388
    09-13-2016 09:58 AM - permalink
    Thanks Just Strokin. I checked it out and it looks like just the ids is there. Do you know if the calibration files are normally in ids? I have the c81 files but it must be missing the calibration for my truck. Do you know how to download them on the ford website? When i put in my calibration it says no files found
  3. gump2388
    09-13-2016 08:27 AM - permalink
    I noticed you gave Terry a link to get the ids calibration files. do u still have that up? I'm looking to get a vcm2 to connect to my 2011 super duty.
  4. checheng
    05-25-2016 08:06 PM - permalink
    sorry I didn't see your message in my profile =D
  5. checheng
    05-25-2016 08:05 PM - permalink
    hi my email is . thanks for helping me out.
  6. lmbbuilders
    03-13-2016 01:33 PM - permalink
    thanks, I appreciate it
  7. lmbbuilders
    03-10-2016 09:44 PM - permalink
    hi, I was reading a few forums and noticed you posted some wiring diagrams for other members. Im in need of some help, I have a 2005 f2520 6.0 diesel with electronic climate control and when my a/c comes on it throws several codes and disables my gas pedal. I know im loosing my 5v reference, but not sure where. I have replaced my compressor, alternator, batteries, low pressure switch, accumulator,oriface tube and disconnected several 5 v reference sensors and all gives me the same results. I know if I disconnect my low pressure switch my defrost and heater works fine, but this is not engaging my compressor. could you email some diagrams to help me troubleshoot? my email address is either way, thanks in advance...hope to hear back from you.
  8. Y2KW57
    11-20-2015 09:53 AM - permalink
    I sent you reps before I had a chance to include a comment with the reps. Thanks for posting the Haltec link!
  9. dagen30
    10-02-2015 10:52 PM - permalink
    Hey man do you still have factory 37.5 gallon tank for sale?

About Me

  • About Just Strokin
    Tallassee, ALabama
    2 Letter State/Province (use "--" for outside USA/
    Country of Residence
    Current Mileage
    Rather not say
    Miles per year
    Rather not say
  • Signature

    2015 F350 Ultra Lariat 6.7L CCLB DRW 3.73 Limited Slip, Green Gem Metallic w/ Caribou accent, Titan 65gal tank, Rapid Heat, Block Heater, Upfitter Switches, Dual Alternators, Camper Package, Cable Lock, Husky Floor Liners, 5th Wheel Prep, 25K 5th Wheel Hitch, Ford Goose Neck Hitch.


Total Posts
Visitor Messages
General Information
  • Last Activity: Today 04:11 PM
  • Join Date: 11-30-2001
  • Referrals: 0

All times are GMT -5. The time now is 04:31 PM.

This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. FordŽ is a registered trademark of the Ford Motor Company.