Ford Truck Enthusiasts Forums - View Profile: Pappys53

Pappys53 is starting off with a positive reputation.

Pappys53 Pappys53 is offline

Senior User

Visitor Messages

Showing Visitor Messages 1 to 4 of 4
  1. jaye
    01-26-2010 04:43 AM - permalink
    I used the hangers off the Ranger; I just centered the axle, measured then drilled holes. I used clamps to hold the springs on while I put some weight on them. I only marked one side like this then removed everything and used the frame to measeure the other side in case it was off then both sides would be the same. They should work on the 53 since both frames are the same the springs are just longer. In the back I didn't have any room to go up/down the hangers just did fit. I think I have some close-up in one of my galleries on the hangers bolted to the frame.
  2. broncomattm
    10-02-2009 10:10 AM - permalink
    Love your paint job, what color paint did you use?
  3. Pappys53
    02-23-2009 11:44 AM - permalink
    Thank you for your reply
  4. oldguy829
    02-22-2009 10:05 PM - permalink
    Its a Hurst. installed by the PO. Looks great, the center section of the knob depresses for the detent. It's a bit sloppy in the feel for which gear you are in, but I haven't checked the linkage to see if it's the install or the shifter. truck has a lot of high dollar parts that were not installed to my satisfaction.

About Me

  • About Pappys53
    hotrods, cowboy action shooting
    2 Letter State/Province (use "--" for outside USA/
    Country of Residence
    Current Mileage
    Rather not say
    Miles per year
    0 - 999


Total Posts
Visitor Messages
General Information
  • Last Activity: 09-05-2016 05:13 PM
  • Join Date: 09-24-2008
  • Referrals: 0

All times are GMT -5. The time now is 05:06 PM.

This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. FordŽ is a registered trademark of the Ford Motor Company.