Go Back   Ford Truck Enthusiasts Forums > Members
Sign in using an external account
Register Forgot Password?

subford has much to be proud ofsubford has much to be proud ofsubford has much to be proud ofsubford has much to be proud ofsubford has much to be proud ofsubford has much to be proud ofsubford has much to be proud ofsubford has much to be proud ofsubford has much to be proud of

subford subford is online now

Post Fiend

Visitor Messages

Showing Visitor Messages 1 to 10 of 198
  1. SwtNSerene
    02-14-2015 04:03 PM - permalink
    "If you put in a GRAY ICM it is the wrong one. The Black ICM very seldom go bad but it tests bad put in another Black one, never a Gray one." In that quote by you I wanted to know what color one do I need for a 1994 E350 van?
  2. SwtNSerene
    02-12-2015 07:20 PM - permalink
    I seen a fourm you replied to and it sounded like you knew your stuff. I have an issue and could really use your help. Cwould you please Msg me back. Than you in advance.
  3. John Parr
    12-27-2014 02:48 PM - permalink
    John Parr
    ive been reading your stuff for a while . good info. I have a 95 f150 4x4 5.0 manual. I think at some time in the past the po swapped engines. I HAVE to pass emmissions. I get codes 113,117,332,334. 113 is always first. there is no spot for an iat sensor,but the plug was under the coil mount. 117.the plug has ref.voltage,sensor is new. I figure the 332 and334 are due to vac hoses[since they snap if you move them at all.the tomato can is leak free. any help I can get would be great. thanks
  4. chris herman
    09-01-2014 05:40 PM - permalink
    chris herman
    hello you helped me a while back with my 89 e350 tioga e350 thanks a lot . I just came back from a 700 mile trip it started out where I had to give it gas to go downhill was holding back than it started making loud hissing like noise than it stopped and free wheeled freely . than got where couldn't run fast had pull over get a tow. tranny not slipping engine shakes when in gear but not in park . cat has been gutted trans fluid don't smell burnt. engine revs up like it should in park also new plugs wires dist cap and fuel filter.
    thanks hope u can help
  5. Conybman
    08-26-2014 12:48 AM - permalink
    Have 95 f150 4x4 w 5.0, swapping in ca model 5.8 MAf, I have the 7 pin connector on the back of my truck for back up lights and brakes.
    I know I have to run a wire to connector 205 pin #2 to run the brakes.

    Questions I have are these. I am a journeyman wireman and mechanic so reading diagrams and rewiring is not an issue!

    What kind of pin, male or female, what size and type of pin and where do I buy 1 to push into pin #2?

    If I buy 3 bosch relays to make my own trailer controls,

    Do I have to remove the in engine comp fuse box to get wires from the 30 amp fuse o the relay and for the other relays?

    Is pushing in a pin to #2 of 205 the only thing I need to do to make the trailer barked work? I know I need a jumper from the under dash to the controller.

    As said connections already made to factory trailer wiring at the rear. But no backup lites ( which is next).
  6. FourXFord2
    08-09-2014 10:30 PM - permalink
  7. FourXFord2
    08-02-2014 07:04 PM - permalink
    It's me again! I have been studying the diagrahms you e-mailed me and have a couple questions. Where is c106,c114. I don't know the year of the harness I used but I'm sure it was from a '90 F250 / 5.8L. I may have to add a wire or 2 to vehicle side of the harness. Also puzzling me is a red/ broken lt blue stripe. Starting system? and what the heck does haynes diagrams mean by NCA? I posted 2 pics on What have you done to your bronco today thread.
  8. guido2008
    07-20-2014 12:15 PM - permalink
    Thank you for the info, what ever happen to the simple stuff ion these things.
  9. guido2008
    07-20-2014 12:04 PM - permalink
    Thank you for the info, what ever happen to the simple stuff ion these things.
  10. ame1lcs
    07-18-2014 12:04 AM - permalink
    Do you know anything about the A/C on an 2010 f150 crew cab? When you use the select button on the center console nothing changes, like changing from blowing out of the dash to blowing out of the feet, or defrost.

About Me

  • About subford
    2 Letter State/Province (use "--" for outside USA/
    Current Mileage
    150,000 - 199,999
    Miles per year
    1,000 - 4,999
  • Signature
    95 F150 302 4R70W EB EX-CAB
    83 F150 Flare Side 351W AOD
    77 F250 351M-2V NP 435/4 Speed 4X4
    Bill K, Kansas Chapter


Total Posts
Visitor Messages
General Information
  • Last Activity: Today 07:09 AM
  • Join Date: 08-26-2005
  • Referrals: 6


Showing Friends 1 to 10 of 36

Participate In The Forums

Create new posts and participate in discussions. It's free!

Sign Up »

All times are GMT -5. The time now is 07:13 AM.

Powered by vBulletin® Version 3.8.7 AC1
Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.
Advertising - Terms of Use - Privacy Statement - Terms of Service - Jobs
This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. Ford® is a registered trademark of the Ford Motor Company.

vbulletin Admin Backup