Conversation Between JBradley500 and D24x4

Thanks for your help! I am a good carpenter but just an average mechanic. I'll go with your advice when I get to that point.

you just need to swap the intake and put on a 4 barrel carb.. no need to change anything else. my truck had a stock reman engine in it when i got it and it also had an edelbrock intake with a holley 4 barrel

heres an intake to use... Edelbrock 3771 Edelbrock Performer Manifolds for Ford

id buy something small for a carb... ~600 cfm 4 barrel holley, demon or edelbrock.

Hi, I was reading the thread about 2v, 4v heads. I have a couple of questions. I was told I could not go to a new intake and 4v carb on my 78 351m unless I upgraded the cam, valves, ETC. Is this correct? Also, will Weiand or Edlebrock intake work with the EGR? Thanks!

Mark