- Desktop Dyno my 352 setup please?
- Forged pistons for 352 .060 over
- 360 rebuild, cyl wall vs .060 overbore
- FE Nationals, anybody going in addition to Ratsmoker?
- 3U crankshaft?
- Rocker Arm Bar
- wet float setting
- 361 truck engine
- FE block cyl. bore sizes, comments?
- I need a good book
- what was they talking about?
- FE446 Assembly Scramble!
- Redoing my 352( more HiPo this time)
- New guy with question
- rocker arms
- 390 will it fit ?
- Duraspark distributor
- question on dizzy springs
- Is there any performance with aftermarket ignition parts?
- A little big block screamer? Or a dumb idea?
- Budget FE Plan? Ideas
- were is the ballist resistor located?
- Help Please!
- Distributor advance question:
- Well here we goooooo
- ID of heads
- DuraSpark teardown?
- Bad news for me and the FE Nationals....
- Pulling 360
- deep sump oil pan on ebay