Yeah, that's where I'm going with this. Bring my sawzall to pull n save, and going to lop off a quarter panel.
I have a shortbox, so I'm going to end up fabricating a short size no matter what. I'm only doing the lower half of the quarter panels (at the seam), so if I go slow, I should get something reasonable straight...
I saw a 67 short box at the Aurora you pull n pay last weekend, but too rusty to bother with.
What bedside do you need? I have a spare rustfree shortbox that needs a panel installed on drivers side. I even cut the panel out of a donor, and the good bed, and never even finished it. I even sandblasted it, then stumbled across a good box that didn't need all that work.
-There's no replacement for Displacement
This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. Ford® is a registered trademark of the Ford Motor Company.