CT machine shops
#1
#2
i dont know where tolland is, but i use Kiwi Engineering in old saybrook. he has done many different types of jobs for me, his pricing is fair and the work is the best i have seen. he will also NEVER bullspit you, wich is really nice. he has done snowmobile, motorcycle, quad, american V8, and custom work for me without any issues to date.
#3
#7
Its gone no where sadly since the intro thread. I'll be starting some serious work soon. I did plug a battery in it, messed around with it. Figured out my radio antenna ground isn't attached to the hood, and that i might need a new turn signal switch. Thanks for asking.
Side thought. I should pick up a engine hoist and get the engine out and tear it down.
Side thought. I should pick up a engine hoist and get the engine out and tear it down.
Trending Topics
#8
I go to http://www.MFG.com when im looking for a <a href="http://www.mfg.com/en/">machine shop</a> to do work for me, sometimes noone will do what i need done, but sometimes they do. and the deals i get are good, I have never gotten anything done the tolland county area, but its worth a shot.
#11
#12
#14
If you call J & R ask for Johnny and tell him CarQuest in Willimantic sent you.
I'm more of a lurker here, the last time I actually logged on was 5/07!
The boys at TurboFord keep me pretty busy so I don't have much time to visit other sites.
Today I was looking for info on swapping a manual tranny into my 1977 F-350 460/C-6 Ranger Camper Special.
I have two 1973 F-250 Custom Camper Special parts trucks but they are both 360-416 FE/T-18 creepers. I'm not sure what I can use other than the pedals.
I found some threads searching and printed them, now I need to read through and see if this is swap is going to be cost effective.
Paul
I'm more of a lurker here, the last time I actually logged on was 5/07!
The boys at TurboFord keep me pretty busy so I don't have much time to visit other sites.
Today I was looking for info on swapping a manual tranny into my 1977 F-350 460/C-6 Ranger Camper Special.
I have two 1973 F-250 Custom Camper Special parts trucks but they are both 360-416 FE/T-18 creepers. I'm not sure what I can use other than the pedals.
I found some threads searching and printed them, now I need to read through and see if this is swap is going to be cost effective.
Paul
Last edited by SickPuppy; 07-14-2010 at 10:31 PM. Reason: Spelling...
Thread
Thread Starter
Forum
Replies
Last Post