Shimming Injectors?
#1
Shimming Injectors?
Anyone ever add shims to their injectors to get higher pop off pressures? Wondered if you have and could notice any difference in performance afterwards.
I have had a few of mine apart in the past and some are shimmed from the factory to get the right pop off pressure. Wondered what adding a washer or two to each injector might do for performance.
I have had a few of mine apart in the past and some are shimmed from the factory to get the right pop off pressure. Wondered what adding a washer or two to each injector might do for performance.
#4
Could care less about bench testing the things...or blowing up my IP either. I got a complete spare engine. And I know a local guy with about 20 used IP's and can get them at about $50 a pop.
I just really want to know if someone has done this and felt that it had a positive impact on power or response.
I just really want to know if someone has done this and felt that it had a positive impact on power or response.
Thread
Thread Starter
Forum
Replies
Last Post
renegade_75
1999 - 2003 7.3L Power Stroke Diesel
25
02-22-2018 10:51 AM
Romel77
Pre-Power Stroke Diesel (7.3L IDI & 6.9L)
20
02-29-2016 11:54 PM
Ron94150
1987 - 1996 F150 & Larger F-Series Trucks
3
08-28-2015 09:35 PM
fordeverpower
FE & FT Big Block V8 (332, 352, 360, 390, 406, 410, 427, 428)
13
07-24-2008 01:25 PM